500~600W Parallel (N+1) With PFC Function SCP-600 s e ri e s Features : AC input 180~260VAC only PF> 0.98 230VAC Protections: Short circuit / Overload / Over voltage / Over temperature Built in remote sense function Built-in remote ON-OFF control Built-in power good signal output Built-in parallel operation function(N+1) Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan 3 years warranty SPECIFICATION ORDER NO. SCP-600-05 SCP-600-09 SCP-600-12 SCP-600-15 SCP-600-18 SCP-600-24 SCP-600-36 SCP-600-48 SCP-600-60 SAFETY MODEL NO. 600S-P005 600S-P009 600S-P012 600S-P015 600S-P018 600S-P024 600S-P036 600S-P048 600S-P060 DC VOLTAGE 5V 9V 12V 15V 18V 24V 36V 48V 60V RATED CURRENT 100A 66A 50A 40A 33.3A 25A 16.6A 12A 10A CURRENT RANGE 0 ~ 100A 0 ~ 66A 0 ~ 50A 0 ~ 40A 0 ~ 33.3A 0 ~ 25A 0 ~ 16.6A 0 ~ 12A 0 ~ 10A RATED POWER 500W 594W 600W 600W 599W 600W 597W 576W 600W OUTPUT RIPPLE & NOISE (max.) Note.2 100mVp-p 100mVp-p 120mVp-p 150mVp-p 180mVp-p 240mVp-p 360mVp-p 480mVp-p 500mVp-p VOLTAGE ADJ. RANGE 3.0% Typical adjustment by potentiometer 20%~100% adjustment by 1~5VDC external control VOLTAGE TOLERANCE Note.3 1.5% 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% LINE REGULATION 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% LOAD REGULATION 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE, HOLD UP TIME 500ms, 250ms, 16ms at full load VOLTAGE RANGE 180 ~ 260VAC 260 ~ 370VDC see the derating curve FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR >0.98 / 230VAC EFFICIENCY (Typ.) 80% 82% 84% 85% 86% 89% 89% 90% 90% INPUT AC CURRENT 5.0A / 230VAC INRUSH CURRENT (max.) 60A / 230VAC LEAKAGE CURRENT (max.) 3.5mA / 240VAC 105 ~ 115% rated output power OVERLOAD Note. 4 Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover 110 ~ 135% Follow to output set up point PROTECTION OVER VOLTAGE Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer OVER TEMPERATURE Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -20 ~ +65 (Refer to output load derating curve) WORKING TEMP. 20 ~ 90% RH non-condensing WORKING HUMIDITY STORAGE TEMP., HUMIDITY -20 ~ +85 10 ~ 95% RH ENVIRONMENT TEMP. COEFFICIENT 0.04% / (0 ~ 50 ) VIBRATION 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950, TUV EN60950-1 approved SAFETY STANDARDS WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG, OP/FG:100M Ohms / 500VDC / 25 / 70% RH EMC Compliance to EN55022 (CISPR22) class A EMI CONDUCTION & RADIATION (Note. 5) HARMONIC CURRENT Compliance to EN61000-3-2,3 EMS IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A POWER GOOD SIGNAL Open collector of NPN transistor DC Voltage Adj., remote sensing, remote control, parallel operation(refer to control terminal instruction manual) SPECIAL FUNCTION COOLING By fan, >20% load or >50 fan on OTHERS MTBF 74.9K hrs min. MIL-HDBK-217F(25 ) DIMENSION 290*120*68mm (L*W*H) PACKING 1.9kg 8pcs / 22kg / CARTON 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. NOTE 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12 twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Current limiting 3 times(1.5s,3.0s,5.0s)Then intelligent auto recovery before shut down 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name: SCP-600-SPEC 2008-05-06500~600W Parallel (N+1) With PFC Function SCP-600 s e ri e s Mechanical Specification Unit:mm 18.5 41 10 190 10 39 30 9.2 11 CN1 6-32-4 1 2 3 4 5 6 7 8 1 2 3 M3(NUT)X3H-4 LED Vadj POS+ NEG- 120 251 30 9 M3(NUT) 3H-4 AIR FLOW BOTTOM SIDE M6 Terminal Pin No. Assignment Control terminal Pin No. Assignment (CN1) : Dinkle 51HDBC-O8P or equivalent Pin No. Assignment Pin No. Assignment Pin No. Assignment Mating With 1 AC/L 1 VS+ 5 PG 2 AC/N 2 VS- 6 PAR Dinkle 51SDB-O8P 3 FG VCI GND or equivalent 3 7 VCO INH 4 8 Derating Curve Ta=25 800 100 700 80 600 550 60 400 40 450 20 300 -20 -10 10 20 30 40 50 60 70 90 110 140 260 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (VAC) 60Hz File Name: SCP-600-SPEC 2008-05-06 LOAD (%) AC INPUT 15 38 OUTPUT POWER (W) DC OUTPUT NEG POS 26.5 68 17 89 14