24LC32AX-E/ST Microchip

24XX32X 24XX32 24AA32A/24LC32A 2 32K I C Serial EEPROM Device Selection Table Description The Microchip Technology Inc. 24AA32A/24LC32A Part VCC Max Clock Temp (24XX32A*) is a 32 Kbit Electrically Erasable PROM. Number Range Frequency Ranges The device is organized as four blocks of 8K x 8-bit (1) 24AA32A 1.8-5.5 400 kHz I memory with a 2-wire serial interface. Low-voltage design permits operation down to 1.8V, with standby 24LC32A 2.5-5.5 400 kHz I, E and active currents of only 1 A and 1mA, Note 1: 100 kHz for VCC <2.5V respectively. It has been developed for advanced, low- power applications such as personal communications Features or data acquisition. The 24XX32A also has a page write capability for up to 32 bytes of data. Functional address Single supply with operation down to 1.8V lines allow up to eight devices on the same bus, for up Low-power CMOS technology to 256 Kbits address space. The 24XX32A is available - 1 mA active current typical in the standard 8-pin PDIP, surface mount SOIC, -1 A standby current (max.) (I-temp) TSSOP and MSOP packages. Organized as 4 blocks of 8K bits (32K bit) 2 Package Types 2-wire serial interface bus, I C compatible Cascadable for up to eight devices ROTATED TSSOP PDIP/SOIC/TSSOP/MSOP (24AA32AX/24LC32AX) Schmitt Trigger inputs for noise suppression A0 1 8 Vcc Output slope control to eliminate ground bounce 1 8 WP SCL A1 2 7 WP 100 kHz (<2.5V) and 400 kHz ( 2.5V) 7 2 Vcc SDA compatibility A2 3 6 SCL 3 6 A0 Vss 5 4 A1 A2 Self-timed write cycle (including auto-erase) Vss 4 5 SDA Page write buffer for up to 32 bytes 2 ms typical write cycle time for page write Hardware write-protect for entire memory Block Diagram Can be operated as a serial ROM Factory programming (QTP) available A0 WP A1 A2 HV Generator ESD protection > 4,000V 1,000,000 erase/write cycles I/O Memory Data retention > 200 years EEPROM XDEC Control Control Array 8-lead PDIP, SOIC, TSSOP and MSOP packages Logic Logic Standard and Pb-free finishes available Page Latches Available temperature ranges: I/O - Industrial (I): -40C to +85C SCL YDEC - Automotive (E): -40C to +125C SDA Vcc Sense Amp. VSS R/W Control *24XX32A is used in this document as a generic part number for the 24AA32A/24LC32A devices. 2003 Microchip Technology Inc. DS21713D-page 124AA32A/24LC32A 1.0 ELECTRICAL CHARACTERISTICS () Absolute Maximum Ratings VCC.............................................................................................................................................................................6.5V All inputs and outputs w.r.t. VSS ......................................................................................................... -0.3V to VCC +1.0V Storage temperature ...............................................................................................................................-65C to +150C Ambient temperature with power applied................................................................................................-65C to +125C ESD protection on all pins ...................................................................................................................................................... 4kV NOTICE: Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only and functional operation of the device at those or any other conditions above those indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for extended periods may affect device reliability. TABLE 1-1: DC CHARACTERISTICS VCC = +1.8V to +5.5V DC CHARACTERISTICS Industrial (I): TA = -40C to +85C Automotive (E): TA = -40C to +125C Param. Symbol Characteristic Min Typ Max Units Conditions No. IH WP, SCL and SDA pins D1 V D2 High-level input voltage 0.7 VCC V D3 VIL Low-level input voltage 0.3 VCC V D4 VHYS Hysteresis of Schmitt 0.05 VCC V (Note 1) Trigger inputs D5 VOL Low-level output voltage 0.40 V IOL = 3.0 mA, VCC = 2.5V D6 ILI Input leakage current 1 AVIN =.1V to VCC D7 ILO Output leakage current 1 AVOUT =.1V to VCC D8 CIN, Pin capacitance 10 pFVCC = 5.0V (Note 1) COUT (all inputs/outputs) TA = 25C, FCLK = 1 MHz D9 ICC write Operating current 0.1 3 mAVCC = 5.5V, SCL = 400 kHz D10 ICC read 0.05 1 mA D11 ICCS Standby current 0.01 1 A Industrial 5 A Automotive SDA = SCL = VCC WP = VSS Note 1: This parameter is periodically sampled and not 100% tested. 2: Typical measurements taken at room temperature. DS21713D-page 2 2003 Microchip Technology Inc.