Features High-performance, Low-power 32-bit Atmel AVR Microcontroller Compact Single-cycle RISC Instruction Set Including DSP Instructions Read-modify-write Instructions and Atomic Bit Manipulation Performance Up to 64DMIPS Running at 50MHz from Flash (1 Flash Wait State) Up to 36DMIPS Running at 25MHz from Flash (0 Flash Wait State) Memory Protection Unit (MPU) Secure Access Unit (SAU) providing User-defined Peripheral Protection 32-bit Atmel picoPower Technology for Ultra-low Power Consumption Multi-hierarchy Bus System AVR High-performance Data Transfers on Separate Buses for Increased Performance 12 Peripheral DMA Channels Improve Speed for Peripheral Communication Microcontroller Internal High-speed Flash 256Kbytes and 128Kbytes Versions Single-cycle Access up to 25MHz FlashVault Technology Allows Pre-programmed Secure Library Support for End AT32UC3L0256 User Applications AT32UC3L0128 Prefetch Buffer Optimizing Instruction Execution at Maximum Speed 100,000 Write Cycles, 15-year Data Retention Capability Flash Security Locks and User-defined Configuration Area Internal High-speed SRAM, Single-cycle Access at Full Speed 32Kbytes Interrupt Controller (INTC) Autovectored Low-latency Interrupt Service with Programmable Priority External Interrupt Controller (EIC) Peripheral Event System for Direct Peripheral to Peripheral Communication System Functions Power and Clock Manager SleepWalking Power Saving Control Internal System RC Oscillator (RCSYS) 32 KHz Oscillator Multipurpose Oscillator, Phase Locked Loop (PLL), and Digital Frequency Locked Loop (DFLL) Windowed Watchdog Timer (WDT) Asynchronous Timer (AST) with Real-time Clock Capability Counter or Calendar Mode Supported Frequency Meter (FREQM) for Accurate Measuring of Clock Frequency Six 16-bit Timer/Counter (TC) Channels External Clock Inputs, PWM, Capture, and Various Counting Capabilities PWM Channels on All I/O Pins (PWMA) 8-bit PWM with a Source Clock up to 150MHz Four Universal Synchronous/Asynchronous Receiver/Transmitters (USART) Independent Baudrate Generator, Support for SPI Support for Hardware Handshaking One Master/Slave Serial Peripheral Interface (SPI) with Chip Select Signals Up to 15 SPI Slaves can be Addressed 32145C06/2013AT32UC3L0128/256 2 Two Master and Two Slave Two-wire Interfaces (TWI), 400kbit/s I C-compatible One 8-channel Analog-to-digital Converter (ADC) with up to 12 Bits Resolution Internal Temperature Sensor Eight Analog Comparators (AC) with Optional Window Detection Capacitive Touch (CAT) Module Hardware-assisted Atmel AVR QTouch and Atmel AVR QMatrix Touch Acquisition Supports QTouch and QMatrix Capture from Capacitive Touch Sensors QTouch Library Support Capacitive Touch Buttons, Sliders, and Wheels QTouch and QMatrix Acquisition On-chip Non-intrusive Debug System Nexus Class 2+, Runtime Control, Non-intrusive Data and Program Trace aWire Single-pin Programming Trace and Debug Interface Muxed with Reset Pin NanoTrace Provides Trace Capabilities through JTAG or aWire Interface 48-pin TQFP/QFN/TLLGA (36 GPIO Pins) Five High-drive I/O Pins Single 1.62-3.6 V Power Supply 2 32145C06/2013