SMART ARM-Based Microcontrollers
SAM D20E / SAM D20G / SAM D20J
DATASHEET COMPLETE
Introduction
Atmel | SMART SAM D20 is a series of low-power microcontrollers using
the 32-bit ARM Cortex -M0+ processor, and ranging from 32- to 64-pins
with up to 256KB Flash and 32KB of SRAM. The SAM D20 devices operate
at a maximum frequency of 48MHz and reach 2.46 CoreMark /MHz. They
are designed for simple and intuitive migration with identical peripheral
modules, hex compatible code, identical linear address map and pin
compatible migration paths between all devices in the product series. All
devices include intelligent and flexible peripherals, Atmel Event System for
inter-peripheral signaling, and support for capacitive touch button, slider and
wheel user interfaces.
Features
Processor
ARM Cortex-M0+ CPU running at up to 48MHz
Single-cycle hardware multiplier
Memories
16/32/64/128/256KB in-system self-programmable Flash
2/4/8/16/32KB SRAM Memory
System
Power-on reset (POR) and brown-out detection (BOD)
Internal and external clock options with 48MHz Digital Frequency
Locked Loop (DFLL48M)
External Interrupt Controller (EIC)
16 external interrupts
One non-maskable interrupt
Two-pin Serial Wire Debug (SWD) programming, test and
debugging interface
Low Power
Idle and standby sleep modes
SleepWalking peripherals
Peripherals
8-channel Event System
Atmel-42129O-SAM D20_Datasheet_Complete-08/2016 Up to five 16-bit Timer/Counters (TC), configurable as either:
One 16-bit TC with two compare/capture channels
One 8-bit TC with two compare/capture channels
One 32-bit TC with two compare/capture channels, by using two TCs
32-bit Real Time Counter (RTC) with clock/calendar function
Watchdog Timer (WDT)
CRC-32 generator
Up to six Serial Communication Interfaces (SERCOM), each configurable to operate as
either:
USART with full-duplex and single-wire half-duplex configuration
2
Inter-Integrated Circuit (I C) up to 400kHz
Serial Peripheral Interface (SPI)
One 12-bit, 350ksps Analog-to-Digital Converter (ADC) with up to 20 channels
Differential and single-ended input
1/2x to 16x programmable gain stage
Automatic offset and gain error compensation
Oversampling and decimation in hardware to support 13-, 14-, 15- or 16-bit resolution
10-bit, 350ksps Digital-to-Analog Converter (DAC)
Two Analog Comparators (AC) with window compare function
Peripheral Touch Controller (PTC)
256-Channel capacitive touch and proximity sensing
I/O
Up to 52 programmable I/O pins
Packages
64-pin TQFP, QFN
64-ball UFBGA
48-pin TQFP, QFN
45-ball WLCSP
32-pin TQFP, QFN
Operating Voltage
1.62V 3.63V
Power Consumption
Down to 70A/MHz in active mode
Down to 8A running the Peripheral Touch Controller
Atmel SAM D20E / SAM D20G / SAM D20J [DATASHEET] 2
Atmel-42129O-SAM D20_Datasheet_Complete-08/2016