HV2722/R4X Microchip

HV2621/HV2721/HV2722 300V, Low-Charge Injection, 16-Channel, High-Voltage Analog Switch Features General Description 300V,16-Channel High-Voltage Analog Switch The HV2621/HV2721/HV2722 devices are 300V, low-charge injection, 16-channel, high-voltage analog 3.3V or 5.0V CMOS Input Logic Level switches. These devices are designed for use in 33 MHz Data Shift Clock Frequency applications requiring high-voltage switching Very Low Quiescent Current (10 A) controlled by low-voltage control signals, such as Low Parasitic Capacitance medical ultrasound imaging, piezoelectric transducer DC to 50 MHz Analog Small-Signal Frequency drivers. HV2621/HV2721 are almost identical to HV2601/2701 but have larger signal range. If the -60 dB Typical Off Isolation at 5.0 MHz /V = 150V, HV2621/HV2721/HV2722 can pass V Excellent Noise Immunity PP NN the analog signal up to 135V. Cascadable Serial Data Register with Latches The HV2721 has integrated bleed resistors on both Flexible Operating Supply Voltage sides of the switches. HV2722 has integrated bleed Integrated Bleed Resistors on the Outputs (both resistors on one side, SWxA only. HV2621 has no sides for HV2721, one side only for HV2722) bleed resistors. The bleed resistor eliminates voltage build-up on capacitive loads such as piezoelectric Applications transducers. Input data are shifted into a 16-bit shift register that Medical Ultrasound Imaging can then be retained in a 16-bit latch. To change all the Nondestructive Testing (NDT) Metal Flaw switch state at the same time, the latch enable bar Detection should be left high until all bits are clocked in. The Multi-Layer Printed Circuit Board (PCB) Tester input data are clocked in at the rising edge of the Piezoelectric Transducer Drivers clock. After all bits are clocked in to the shift register, a Inkjet Printer Head negative pulse of the latch enable bar changes all the switch ON/OFF states defined by input data at the Optical MEMS Module same time. Using the HVCMOS technology, these devices combine 300V high-voltage bilateral DMOS switches and low-power CMOS logic to provide efficient control of high-voltage analog signals. These devices are suitable for various combinations of /V : +60V/-240V, high-voltage supplies, e.g., V PP NN +150V/-150V, and +260V/-40V. Package Types HV2621/HV2721/HV2722 9x9x1.0mm QFN (TOP VIEW) 64 1 2019 Microchip Technology Inc. DS20006082A-page 1HV2621/HV2721/HV2722 Block Diagram Bleed Level Output Latches Resistors Shifter Switches SW0A D LE CLR SW0B SW1A D LE CLR SW1B SW2A D CLK LE CLR SW2B 16-Bit D Shift IN Register D OUT SW14A D LE CLR SW14B SW15A D LE CLR SW15B V V V R DD GND LE CLR NN PP GND HV2721 has bleed resistors at SWxA and SWxB HV2722 has bleed resistors at SWxA only DS20006082A-page 2 2019 Microchip Technology Inc.