PL133-37TC-R Microchip

PL133-37 Low-Power, 1.62V to 3.63V, 1MHz to 150MHz, 1:3 Fanout Buffer IC FEATURES DESCRIPTION The PL133-37 is an advanced fanout buffer design 3 LVCMOS Outputs for high performance, low-power, small form-factor 12mA Output Drive Strength applications. The PL133-37 accepts a reference Input/Output Frequency: clock input of 1MHz to 150MHz and produces three o Reference Clock: 1MHz to 150MHz outputs of the same frequency. Reference clock in- Supports LVCMOS or Sine Wave Input Clock puts may be LVCMOS or sine-wave signals (the in- Very Low Jitter and Phase Noise puts are internally AC-coupled). Offered in a small Low Current Consumption 3mm x 3mm SOT23, the PL133-37 offers the best Single 1.8V, 2.5V, or 3.3V, 10% Power Supply phase noise and jitter performance and lowest power Operating Temperature Range consumption of any comparable IC. o 0C to 70C (Commercial) o -40C to 85C (Industrial) Available in SOT23-6L GREEN/RoHS Compliant Packages PACKAGE PIN CONFIGURATION CLK1 1 6 CLK2 GND 2 5 VDD FIN 3 4 CLK0 SOT23-6L BLOCK DIAGRAM CLK0 FIN CLK1 CLK2 Micrel Inc. 2180 Fortune Drive San Jose, CA 95131 USA tel +1(408) 944-0800 fax +1(408) 474-1000 www.micrel.com Rev 02/24/15 Page 1 PL133-37 Low-Power, 1.62V to 3.63V, 1MHz to 150MHz, 1:3 Fanout Buffer IC PIN DESCRIPTION Package Pin Name Type Description SOT23-6L CLK1 1 O Output clock GND 2 P Ground connection FIN 3 I Reference clock input CLK0 4 O Output clock VDD 5 P Power supply CLK2 6 O Output clock LAYOUT RECOMMENDATIONS The following guidelines are to assist you with a performance optimized PCB design: Signal Integrity and Termination Considerations Decoupling and Power Supply Considerations - Keep traces short - Place decoupling capacitors as close as possible to the V pin(s) to limit noise from the power supply DD - Trace = Inductor. With a capacitive load this equals ringing - Multiple V pins should be decoupled separately DD for best performance. - Long trace = Transmission Line. Without proper termi- nation this will cause reflections (looks like ringing). - Addition of a ferrite bead in series with V can DD help prevent noise from other board sources - Design long traces as striplines or microstrips with defined impedance. - Value of decoupling capacitor is frequency de- pendant. Typical value to use is 0.1 F. - Match trace at one side to avoid reflections bouncing back and forth. Typical CMOS termination Place Series Resistor as close as possible to CMOS output CMOS Output Buffer To CMOS Input (Typical buffer impedance 20) 50 line Series Resistor Use value to match output buffer impedance to 50 trace. Typical value 30 Micrel Inc. 2180 Fortune Drive San Jose, CA 95131 USA tel +1(408) 944-0800 fax +1(408) 474-1000 www.micrel.com Rev 02/24/15 Page 2