VS-501-0074-1000M0 VCSO VS-501-0074-1000M0 Nominal frequency (f0) 1000 MHz Performance Specications Frequency stabilities Parameter Min Typical Max Units Condition APR (under all cond. for life cycle): > 20ppm, Additional information pos. slope,-40..+85 C,dVs,dLoad,initial,aging 15y. Frequency Tuning Parameter Min Typical Max Units Condition Absolute pulling range (APR) (df/f0) 20 ppm ext. tuning voltage 0 to 3.3V slope (pos./neg.) positiv Frequency control input impedance 100 kOhm Modulation bandwidth 20000 Hz -3 dB RF output Parameter Min Typical Max Units Condition Signal LVPECL Load 45 50 55 Ohm Duty cycle 40 60 % 50 % V Low 1.36 1.68 V V High 2.16 2.42 V Page 1 of 4 Vectron International Supply voltage Parameter Min Typical Max Units Condition Supply voltage (Vs) 3.14 3.3 3.47 V Current consumption steady state 100 mA Vsnom & 25 C Additional Parameters Parameter Min Typical Max Units Condition Phase Noise -46 -35 dBc/Hz 10Hz -74 -65 dBc/Hz 100Hz -100 -92 dBc/Hz 1kHz -128 -122 dBc/Hz 10kHz -146 -143 dBc/Hz 100kHz -150 -147 dBc/Hz 1MHz -148 dBc/Hz 10MHz psec Jitter 0.05 12kHz to 20MHz (RMS) Additional information No through holes in VCSO PCB > Routing allowed below device Processing & Packing handling&processing note Additional Environmental Conditions Parameter Description 100% RoHS 6 compliant RoHS compliance non-washable device Washable ESD HBM JESD22-A114F Class 1B - 10x1000V Mechanical Shock MIL-STD-202 Meth 213B Cond. F - 1500g 0,5ms 6 shocks in each direction Vibration, Sine MIL-STD-883 Meth 2007 Cond A - 20g 20-2000Hz 4x in each 3 axis 4min sweep time JESD22-A113-B - only if > MSL 1 Moisture Sen. Level Solderabiltiy J-STD-002C Cond. A, Trough hole device Cond.B, SMD ( correspond to MIL-STD-883 Meth 2003) - 255 C (diving Time 5 0,5sec.) Dip&Look with 8h damp pre-treatment: solder wetting >95% MIL-STD-202 Meth108A Cond C - 1000h 105 C power on High temp operating life(HTOL) IEC 60068-2-1 Cond. Ae - 1000h -40 C power on Low temp operating life(LTOL) Reow Simulation Test MIL-STD-202G Meth 210F Cond. K - Total 3x Lead free prole (for SMD) Temperature Cycling JESD22-A104-D Cond.G - 1000cycles -40/+125 C cycle time 30 min. Absolute Maximum Ratings Parameter Min Typical Max Units Condition Operable temperature range -40 +85 C Storage temperature range -40 +95 C Page 2 of 4 Vectron International