2. Soldering the headers Before using your click board, make sure to solder 1x8 male headers to both left and right side of the board. Two 1x8 male headers are included with the board in the package. 1 EEPROM click 2 3 1. Introduction 4. Essential features EEPROM Click with its DIP 24C08 module gives additional 8kbit EEPROM memory to your design. The 24C08 module supports 2 both the 100kHz I C standard-mode and the 2 400kHz I C fast-mode. It has write control Turn the board upside down so that Turn the board upward again. Make sure input, byte or page write (up to 16 bytes), bottom side is facing you upwards. Place to align the headers so that they are random and sequential read modes and shorter parts of the header pins in both perpendicular to the board, then solder the automatic address incrementing. You can put soldering pad locations. pins carefully. other EEPROM chip with dieff rent capacity in DIP8 socket. EEPROM Click is an accessory board in 3. Plugging the board in mikroBUS form factor. Its a compact click and easy solution for adding more EEPROM Once you have soldered the headers your memory to your device. It features DIP board is ready to be placed into desired BOARD 24C08 8kbit serial EEPROM module in DIP 8 mikroBUS socket. Make sure to align the www.mikroe.com socket. EEPROM Click communicates with cut in the lower-right part of the board 2 target board via I C interface. The board is with the markings on the silkscreen at the EEPROM click Manual designed to use 3.3V and 5V power supply. mikroBUS socket. If all of the pins are ver. 1.00 It has a LED diode (GREEN) that indicates the aligned correctly, push the board all presence of power supply. the way into the socket. 0 100000 0210646. SMD Jumpers 5. EEPROM Click Board Schematic With J2, J3 and J4 SMD jumpers you can assign the unique 3-bit chip enable address (A0, A1, A2) to each DIP EEPROM memory. There is a limited number of EEPROMs you can connect 2 to the same I C bus depending on the memory capacity (eg. 1x16Kbit, 2x8Kbit, 4x4Kbit, 8x2Kbit or 8x1Kbit). SMD jumper J1 is used to select 5V or 3.3V power supply (default VCC position is 3.3V). PWR SEL J1 7. Code Examples VCC VCC VCC J2 Once you have done all the necessary C1 WP preparations, its time to get your click AN PWM R1 RST INT 2K2 board up and running. We have provided 100nF CS TX R2 R3 the examples for mikroC, mikroBasic and SCK RX U1 SCL 4K7 4K7 J3 SCL POWER MISO mikroPascal compilers on our Libstock A0 1 8 SDA LD1 A0 VCC SDA MOSI A1 2 7 WP website. Just download them and you are A1 WP +3.3V +5V A2 3 6 SCL ready to start. A2 SCL GND GND 4 5 SDA VSS SDA MIKROBUS DEVICE CONN. J4 24C08 R4 .com 100K 8. Support MikroElektronika oers ff Free Tech Support (www.mikroe.com/esupport) until the end of product lifetime, so if something goes wrong, we are ready and willing to help MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document. Specification and information contained in the present schematic are subject to change at any time without notice. Copyright 2012 MikroElektronika. All rights reserved.