2. Soldering the headers Before using your click board, make sure to solder 1x8 male headers to both left and right side of the board. Two 1x8 male headers are included with the board in the package. 1 Adapter click 2 3 4. Essential features 1. Introduction There are two ways of establishing such connection: using male or female IDC10 connectors. Both are provided with the package. You may solder male IDC10 header on the top side of Adapter Click and connect the add-on board directly or via IDC10 at Turn the board upside down so that Turn the board upward again. Make sure cable. In some cases, female header socket is bottom side is facing you upwards. Place to align the headers so that they are a better choice. Solder it either on the top, or shorter parts of the header pins in both perpendicular to the board, then solder the the bottom side, depending on which one is soldering pad locations. pins carefully. more convenient in given circumstances. Adapter Click is an accessory board in mikroBUS form factor. Its a compact 3. Plugging the board in and easy solution for adding mikroBUS click to IDC10 adapter to your design. It Once you have soldered the headers your features 2x5 connection pads and two board is ready to be placed into desired 2 BOARD jumpers for SPI/IC selection. Adapter mikroBUS socket. Make sure to align the www.mikroe.com Click communicates with the target board cut in the lower-right part of the board 2 microcontroller via mikroBUS I C (SDA, with the markings on the silkscreen at the Adapter click Manual SCL), SPI (MISO, MOSI, SCK, CS), UART mikroBUS socket. If all of the pins are ver. 1.00 (RX, TX), INT and PWM lines. The board is aligned correctly, push the board all designed to use 3.3V and 5V power supply. the way into the socket. 0 100000 0238606. Jumpers 5. Adapter Click Board Schematic 2 There are two jumpers for SPI/I C selection VCC3.3 VCC5 and one used to select whether 3.3V or 5V power supply will be used. J1 VCC 7. Code Examples Once you have done all the necessary VCC RC0 SDA preparations, its time to get your click AN PWM RC1 MISO RST INT board up and running. We have provided RC0 1 2 RC1 CS TX CS TX CS 3 4 SCK/SCL SCK RX J2 the examples for mikroC, mikroBasic and SCK RX MISO/SDA 5 6 MOSI MISO SCL MISO/SDA mikroPascal compilers on our Libstock SCL MISO TX 7 8 RX MOSI SDA SDA MOSI website. Just download them and you are 9 10 SCL +3.3V +5V SCK ready to start. CN2 GND GND MIKROBUS DEVICE CONN. J3 SCK/SCL .c.comom 8. Support MikroElektronika o ers Free Tech Support (www.mikroe.com/esupport) until the end of product lifetime, so if something goes wrong, we are ready and willing to help MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document. Speci cation and information contained in the present schematic are subject to change at any time without notice. Copyright 2013 MikroElektronika. All rights reserved.