2. Soldering the headers Before using your click board , make sure to solder 1x8 male headers to both left and right side of the board. Two 1x8 male headers are included with the board in the package. 1 4. Essential features Angle click 2 3 Angle click is intended for use with a rotating bipolar magnetic target. The advanced linearization, offset and gain adjustment options enable a wide variety of applications. Those include setting up a digital potentiometer, sensing motor rotation, or in automotive applications for power steering and throttle sensing. With a refresh rate of Turn the board upside down so that Turn the board upward again. Make sure 32 micro seconds and a 12-bit resolution, the the bottom side is facing you upwards. to align the headers so that they are A1332 delivers precise angle measurements. Place shorter pins of the header into the perpendicular to the board, then solder the Furthermore, you can configure the output appropriate soldering pads. pins carefully. dynamic range, output scaling and filtering to 1. Introduction adjust it for specific use. Angle click carries an A1332 contactless magnetic angle position sensor. The sensing 3. Plugging the board in circuitry relies on the Hall Effect to detect click the vector of a nearby magnetic field in a Once you have soldered the headers your 360 two-dimensional plane parallel to the board is ready to be placed into the desired BOARDS surface of the chip. The device also includes mikroBUS socket. Make sure to align the cut www.mikroe.com EEPROM for storing calibration parameters. in the lower-right part of the board with the Angle click communicates with the target markings on the silkscreen at the mikroBUS MCU through the mikroBUS I2C interface socket. If all the pins are aligned Angle click Manual v100 (SCL, SDA). Designed to use either a 3.3V or correctly, push the board all the a 5V power supply. way into the socket. 01000000924778. Code examples 5. Schematic Once you have done all the necessary preparations, its time to get your click board up and running. We have provided examples for mikroC , mikroBasic and mikroPascal VCC VCC VCC VCC compilers on our Libstock website. Just download them and you are ready to start. R1 U1 R2 R3 AN PWM 1 14 RST INT DGND DGND 4K7 2 13 2K2 2K2 CS TX BYP SA0 .com 3 12 SCK RX DGND SA1 SCL 4 11 SCL MISO SCL AGND SCL SDA 5 10 SDA MOSI SDA VCC SDA 6 9 +3.3V +5V VCC DGND 7 8 GND GND AGND TEST PWR C1 C2 A1332 MIKROBUS DEVICE CONN.1 9. Support 0.1uF 0.1uF MikroElektronika offers free tech support VCC (www.mikroe.com/support) until the end of GND GND GND GND GND GND GND the products lifetime, so if something goes wrong, were ready and willing to help PWR SEL 6. Dimensions 7. SMD jumper 10. Disclaimer Angle click features an MikroElektronika assumes no responsibility mm mils SMD jumper (zero ohm or liability for any errors or inaccuracies resistor) that lets you that may appear in the present document. LENGTH 28.6 1125 switch between a 3.3V Specification and information contained in or a 5V power supply. WIDTH 25.4 1000 the present schematic are subject to change HEIGHT* 3.3 130 at any time without notice. 28.6 mm / 1125 mils * without headers Copyright 2015 MikroElektronika. All rights reserved. 25.4 mm / 1000 mils