VCP Monitor 2 Click PID: MIKROE-4126 VCP Monitor 2 Click is a three-channel, high-side current and bus voltage monitor with alert indication function ensuring the intended application works within desired operating conditions. Featured chip INA3221-Q1, by Texas Instruments, monitors both shunt voltage drops and bus supply voltages, in addition to having programmable conversion times and averaging modes for these signals. The INA3221-Q1 offers both critical and warning alerts to detect multiple programmable out-of-range conditions for each channel. The INA3221-Q1 senses current on buses that can vary from 0V to 26V. The device is powered from a single 2.7V to 5.5V supply, and draws 350 A (typical) of supply current. The I2C and SMBUS-compatible interface features four programmable addresses. VCP Monitor 2 Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board comes as a fully tested product, ready to be used on a system equipped with the mikroBUS socket. Specifications Type Measurements Applications Electronic control units, digital clusters, rear- seat entertainment, infotainment, computers, power management, telecom equipment, battery chargers, power supplies, test equipment. On-board modules VCP Monitor 2 Click uses the INA3221-Q1, a three-channel, high-side current and bus voltage monitor, from Texas Instruments and PCA9538A, an IO expander with interrupt and reset, from NXP Semiconductors. Key Features Shunt voltage drops and bus supply voltages monitoring, programmable conversion times, critical and warning alerts, single power supply, 350 A of supply current Interface I2C Compatibility mikroBUS Click board size L (57.15 x 25.4 mm) Input Voltage 3.3V or 5V Resources mikroBUS mikroSDK Click board Catalog Click boards Downloads VCP monitor 2 Click schematic VCP monitor 2 click 2D and 3D files INA3221-Q1 datasheet VCP monitor 2 click example on Libstock Powered by TCPDF (www.tcpdf.org)