Single Wire CAN Click PID: MIKROE-4225 Single Wire CAN Click is a compact add-on board that contains an IC for a single wire data link capable of operating with various protocols such as the Controller Area Network (CAN). This board features the NCV7356D1R2G, Single Wire CAN transceiver from ON Semiconductor, which operates from a supply voltage from 5V to 27V with bus speed up to 40 kbps. It supports many additional features like an under-voltage lockout, a timeout for faulty blocked input signals, output blanking time in case of bus ringing, and a very low sleep mode current. This Click board can be used in industrial equipment, in-vehicle, and industrial networking, and in applications where the high data rate is not required and a lower data rate can achieve cost reductions. Single Wire CAN Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board comes as a fully tested product, ready to be used on a system equipped with the mikroBUS socket. Specifications Type CAN Applications Can be used in industrial equipment, and applications such as in-vehicle and industrial networking. On-board modules Single Wire CAN Click is based on the NCV7356D1R2G, a Single Wire CAN transceiver from ON Semiconductor, which operates from a supply voltage from 5V to 27V with a bus speed up to 40 kbps. Key Features Low power consumption, fully integrated receiver filter, loss of ground protection, undervoltage lockout, and more. Interface GPIO,UART Compatibility mikroBUS Click board size M (42.9 x 25.4 mm) Input Voltage 3.3V or 5V Resources mikroBUS mikroSDK Click board Catalog Click boards Downloads Single Wire CAN click 2D and 3D files NCV7356 datasheet Single Wire CAN click example on Libstock Single Wire CAN click schematic Powered by TCPDF (www.tcpdf.org)