TRPRG1VA1C000E2G Molex

TRPRG1-G 1.25G Ethernet 1000BASE-T and 10/100/1000BASE-T Copper SFP Transceiver Document History Author Remarks Date Status 2011/12/06 Version 01 Yingying Cai Preliminary Specifications 46335 Landing Pkwy Fremont CA 94538-6407Tel: 510-933-7200Fax: 510-933-7300Email: info oplink.com Web: www.oplink.com Page 1 of 6 S0306. Rev.01. 2011-12-06 TRPRG1-G 1.25G Ethernet 1000BASE-T and 10/100/1000BASE-T Copper SFP Transceiver Features Up to 1.25Gb/s bi-directional data links Lead Free Design & Compliant with RoHS Directive 2002/95/EC Compatible with SFP MSA Compatible with IEEE 802.3-2002 and IEEE 802.3ab Gigabit Ethernet and 1000BASE-T Specifications Hot-pluggable SFP footprint TX Disable and RX Los/without Los function Fully metallic enclosure for low EMI Low power dissipation (1.05W typical) Compact RJ-45 connector assembly Access to physical layer IC via 2-wire serial bus 1000 BASE-T operation in host systems with SERDES interface 10/100/1000Mbps compliant in host systems with SGMII interface Operating case temperature range of 0C to +70C (Commercial) or -40C to +85C (Industrial) Description TRPRG1-G Copper Small Form Pluggable (SFP) which can be accessed with address of A0h via the 2wire transceivers is high performance, cost effective module serial CMOS EEPROM protocol. The physical IC can also compliant with the Gigabit Ethernet and 1000BASE-T be accessed via 2-wire serial bus at address ACh. standards as specified in IEEE 802.3-2002 and IEEE All modules satisfy Class I Laser Safety requirements in 802.3ab, which supports 1000Mbps data-rate up to 100 accordance with the U.S. FDA/CDRH and international meters reach over unshielded twisted-pair category 5 IEC-60825 standards. cable. The module supports 1000Mbps full duplex data- The transceivers operate from a single +3.3V power links with 5-level Pulse Amplitude Modulation (PAM) supply over an operating case temperature range of 0C signals. All four pairs in the cable are used with symbol to +70C (Commercial) or -40C to +85C (Industrial). The rate at 250Mbps on each pair. The module provides housing is made of metal for EMI immunity. standard serial ID information compliant with SFP MSA, Absolute Maximum Ratings Parameters Symbol Min Max Units Storage Temperature T - 40 + 85 C ST Commercial 0 + 70 1 Operating Case Temperature T C OP Industrial - 40 + 85 1 Measured on top side of SFP module at the front center vent hole of the cage. 46335 Landing Pkwy Fremont CA 94538-6407Tel: 510-933-7200Fax: 510-933-7300Email: info oplink.com Web: www.oplink.com Page 2 of 6 S0306. Rev.01. 2011-12-06