RFM products are now Murata products. SF1059A Low Loss UHF SAW Filter 9.1 x 7.1 mm Version of SF1059A-1 Single-ended or Balanced Operation 350.0 MHz Pb Complies with Directive 2002/95/EC (RoHS) SAW Filter Absolute Maximum Ratings Rating Value Units Maximum Incident Power in Passband +10 dBm Maximum DC Voltage Between any 2 Terminals 30 VDC Storage Temperature Range -40 to +85 C Suitable for lead-free soldering - Maximum Soldering Profile 260 C for 30 s SM9171-10 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units f1350.00 Nominal Center Frequency MHz C Passband: IL 810.0 dB Insertion Loss at fc BW 1, 2 400 3 dB Passband 600 kHz 3 dB Amplitude Variation over fc 250 kHz 0.5 1.0 P-P ns Group Delay Variation over fc 400 kHz GDV 200 250 P-P 1, 2, 3 Rejection referenced to IL: 35 40 (fc - 8.0) to (fc - 2.0) and (fc + 2.0) to (fc + 8.0) MHz dB (fc - 50) to (fc - 8.0) and (fc + 8.0) to (fc + 50) MHz 40 45 Ultimate Rejection 50 Operating Temperature Range T +70 C 1-20 A Impedance Matching to 50 unbalanced External L-C Case Style SM9171-10 9.1 x 7.1 mm Nominal Footprint Lid Symbolization (YY=year, WW=week, S=shift, =sequence code) RFM SF1059A YYWWS CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specitication apply over the operating temperature range with filter soldered to the specified demonstration board with impedanced matching to 50 network analyzer. 2. Unless noted otherwise, all frequency specitications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4. LRIP or L after the part number indicates low rate initial production and ENG or E indicates engineering prototypes. 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. 2010-2014 by Murata Electronics N.A., Inc. SF1059A (R) 3/18/14 Page 1 of 4 www.murata.comSF1059A Filter Plots 2010-2014 by Murata Electronics N.A., Inc. www.murata.com SF1059A (R) 3/18/14 Page 2 of 4