SF2001E RF Filter for Mobile Communication Applications No Matching Circuit Required 3.0 x 3.0 x 1.3 mm Package 1960 MHz Complies with Directive 2002/95/EC (RoHS) Pb SAW Filter Absolute Maximum Ratings Rating Value Units Maximum Input Power +10 dBm DC Voltage on any Non-ground Terminal 3 VDC Storage Temperature Range in Tape and Reel -40 to +85 C Maximum Soldering Profile, 5 cycles/10 seconds maximum 265 C SM3030-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Nominal Operating Frequency f 1960 MHz C Passband Insertion Loss, 1930 -1990 MHz IL 2.35 4.0 dB Amplitude Ripple, 1930 -1990 MHz 1.4 2.4 dB P-P Attenuation Referenced to 0 dB DC to1870 MHz 25.0 32.0 dB 1870 to 1910 MHz 10.0 21.0 dB 2010 to 2040 MHz 4.5 10.0 dB 2040 to 2050 MHz 20.0 50 dB 2050 to 3800 MHz 25.0 29.0 dB 3800 to 5000 MHz 22.0 15.0 dB 5000 to 6000 MHz 10.0 15.0 VSWR, 1930 to 1990 MHz 1.7 2.4 Z Source impedance 50 S Z Load impedance 50 L T Operating Temperature -30 +80 C A Case Style SM3030-6 3 x 3 mm Nominal Footprint Lid Symbolization (Y=year, WW=week S=shift) 652 YWWS Electrical Connections Connection Terminals Input 2 Output 5 Ground All others CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating tem- andEN or indicatesengineering prototypes perature range with filter soldered to the specified demonstration board 5. The design, manufacturing process, and specifications of this filter are with impedance matching to 50 and measured with 50 network ana- subject to change. lyzer. 6. Either Port 1 or Port 2 may be used for either input or output in the design. 2. Unless noted otherwise, all frequency specifications are referenced to the However, impedances and impedance matching may vary between Port 1 nominal center frequency, fc. and Port 2, so that the filter must always be installed in one direction per 3. Rejection is measured as attenuation below the minimum IL point in the the circuit design. passband. Rejection in final user application is dependent on PCB layout 7. US and international patents may apply. and external impedance matching design. See Application Note No. 42 for 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered details. trademarks of Murata Manufacturing Co., Ltd. 4.LRI or after the part number indicateslow rate initial productio Copyright Murata Manufacturing Co., Ltd. All rights reserved. SF2001E (R) 5/17/16 Page 1 of 5 www.murata.comFrequency Characteristics: Copyright Murata Manufacturing Co., Ltd. All rights reserved. SF2001E (R) 5/17/16 Page 2 of 5 www.murata.com