NJM2504 VIDEO DIFFERENTIAL OUTPUT DRIVER QGENERAL DESCRIPTION Q PACKAGE OUTLINE The NJM2504 is video differential output driver. The single-end signal is converted to the differential signal. The single-end signal can be transmitted by the differential signal by the connection with NJM2507. And, it is converted to the single-end signal by the NJM2507. The common mode noise can be removed because of the differential NJM2504RB1 motion transmission, and it is the best for the transmission of car AV system. Q FEATURES O Operating Voltage 4.5 to 9.5V O Input: Single-end signal, Output: Differential signal O Internal 6dB Amplifier O Internal 75ohm Driver O Internal SAG Correction Circuit O Bipolar Technology O Package Outline TVSP8 Q PIN CONNECTION 1: V+ 2: Power Save 1 8 3: VIN 2 7 4: GND 5: Vsagn 3 6 6: Voutn 4 5 7: Vsagp 8: Voutp Q BLOCK DIAGRAM Vcc PowerSave VOUTP VSAGP VIN VSAGN Bias VOUTN GND Ver.6 - 1 - NJM2504 Q ABSOLUTE MAXIMUM RATINGS (Ta=25C) PARAMETER SYMBOL RATINGS UNIT + Supply Voltage V 10 V Power Dissipation P 580(Note1) mW D Operating Temperature Range Topr -40 to +85(Note2) C Storage Temperature Range Tstg -40 to +150 C (Note 1) At on a board of EIA/JEDEC specification. (114.3 x 76.2 x 1.6mm 2 layers, FR-4) (Note 2) It has high operating temperature range product. (-40 to +105C) Q RECCOMENDED OPERATING CONDITIONS (Ta=25C) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX.UNIT Operating voltage Vopr 4.5 - 9.0 V + Q ELECTRICAL CHRACTERISTCS (V =5V, RL=150ohm,Ta=25 C) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX.UNIT Supply Current I No signal - 16 20 mA CC Supply Current Isave Power save mode - 0.3 0.5 mA at Power Save Mode Maximum Output Level Vom Vin=100kHz,sin-signal, THD=1%, 2.2 2.4 - Vp-p Voltage Gain Gv Vin=1MHz, 1.0Vp-p sin-signal 5.7 6.2 6.7 dB Frequency Characteristics Gf Vin=10MHz/1MHz, 1.0Vpp sin-signal -1.0 0 1.0 dB Differential Gain DG Vin=1.0Vp-p 10step video signal - 0.5 - % Differential Phase DP Vin=1.0Vp-p 10step video signal - 0.5 - deg + SW Voltage High Level VthH 2.2 - V V SW Voltage Low Level VthL 0 - 1.0 V SW Sink Current High Level IthH V=5V - - 120 A SW Sink Current Low Level IthL V=0.3V - - 8.0 A Q CONTROL CHRACTERISTC PARAMETER STATUS MODE H Power save: OFF Active mode Power Save L Power save: ON Non-Active mode (Mute) OPEN Power save: ON Non-Active mode (Mute) Ver.6 - 2 -