NJM2507RB1-TE1 Nisshinbo

NJM2507 VIDEO DIFFERENTIAL INPUT RECEIVER QGENERAL DESCRIPTION Q PACKAGE OUTLINE The NJM2507 is video differential input receiver. The differential signal is converted to the single-end signal. The single-end signal can be transmitted by the differential signal by the connection with NJM2504. And, it is converted to the single-end signal by the NJM2507. NJM2507RB1 The common mode noise can be removed because of the differential MSOP8(TVSP8) motion transmission, and it is the best for the transmission of car AV system. Q FEATURES O Operating Voltage 4.5 to 9.5V O Input: Differential signal, Output: Single-end signal O Internal 6dB Amplifier *Differential input mode O Internal 75ohm Driver O Internal SAG Correction Circuit O Bipolar Technology O Package Outline MSOP8(TVSP8)* *MEET JEDEC MO-187-DA / THIN TYPE Q PIN CONNECTION 1: V+ 2: Power Save 1 8 3: Vinp 2 7 4: Vinn 5: Vref 3 6 6: GND 7: Vsag 4 5 8: Vout Q BLOCK DIAGRAM Vcc PowerSave Vref Bias Vinp Vout Vinn Vsag GND Ver.6 - 1 - NJM2507 Q ABSOLUTE MAXIMUM RATINGS (Ta=25C) PARAMETER SYMBOL RATINGS UNIT + Supply Voltage V 10 V Power Dissipation P 580(Note1) mW D Operating Temperature Range Topr -40 to +85(Note2) C Storage Temperature Range Tstg -40 to +150 C (Note 1) At on a board of EIA/JEDEC specification. (114.3 x 76.2 x 1.6mm 2 layers, FR-4) (Note 2) It has high operating temperature range product.(-40 to +105C) Q RECCOMENDED OPERATING CONDITIONS (Ta=25C) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX.UNIT Operating voltage Vopr 4.5 - 9.0 V + Q ELECTRICAL CHRACTERISTCS (V =5V, RL=150ohm,Ta=25 C) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX.UNIT Supply Current I No signal - 10 12 mA CC Supply Current Isave Power save mode - 0.3 0.5 mA at Power Save Mode Maximum Output Level Vom Vin=100kHz,sin-signal, THD=1%, 2.2 2.4 - Vp-p Voltage Gain Gv Vin=1MHz, 1.0Vp-p sin-signal -0.3 0.2 0.7 dB Frequency Characteristics Gf Vin=10MHz/1MHz, 1.0Vpp sin-signal -1.0 0 1.0 dB Common Mode CMR Vin=20kHz, 1.0Vpp,sin-signal - -50 - dB Rejection Ratio Differential Gain DG Vin=1.0Vp-p 10step video signal - 0.5 - % Differential Phase DP Vin=1.0Vp-p 10step video signal - 0.5 - deg + SW Voltage High Level VthH 2.2 - V V SW Voltage Low Level VthL 0 - 1.0 V SW Sink Current High Level IthH V=5V - - 120 A SW Sink Current Low Level IthL V=0.3V - - 8.0 A Q CONTROL CHRACTERISTC PARAMETER STATUS MODE H Power save: OFF Active mode L Power save: ON Non-Active mode (Mute) Power Save OPEN Power save: ON Non-Active mode (Mute) Ver.6 - 2 -