SS22SDH2LE NKK Switches

Ultra-Miniature Illuminated Slides Series SS Distinctive Characteristics Top or side actuation permits flexible board design. Bright, LED illumination at tip of actuator. Compact dimensions and low profile allow high density mounting and close stacking of PC boards. Crisp actuation positively indicates circuit status. Double molded thermoset base and thermoplastic housing prevent loosening of terminals due to high soldering temperatures. H Sliding twin contact mechanism with self-cleaning action provides smooth actuation and produces high contact reliability. Insert molded terminals lock out flux, solvents, and other contaminants. Inch terminal spacing for standard PC board grid (.100 x .100). Actual Size www.nkkswitches.com H49 2/ 23 /1 8 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers TogglesSeries SS Ultra-Miniature Illuminated Slides General Specifications Electrical Capacity (Resistive Load) Power Level: 0.1A 30V DC Other Ratings Contact Resistance: 20 milliohms maximum Insulation Resistance: 100 megohms minimum 500V DC Dielectric Strength: 500V AC minimum 1 minute minimum Mechanical Life: 10,000 operations minimum Electrical Life: 10,000 operations minimum Contact Timing: Shorting (make-before-break) Total Travel: .079 (2.0mm) Materials & Finishes Actuator: Polyacetal Upper Case: Polyacetal Lower Case: Glass fiber reinforced polyester Movable Contactor: Phosphor bronze with silver plating Interior Base: Phenolic resin (thermoset) Terminals: Brass with silver plating over copper plating Environmental Data Operating Temp Range: 15C through +60C (+5F through +140F) H Humidity: 90 ~ 95% humidity for 96 hours 40C (104F) Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute 3 right angled directions for 2 hours 2 Shock: 50G (490m/s ) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) PCB Processing Soldering: Wave Soldering: For non-supported through-hole, see Profile B in Supplement section. For supported through-hole, 5 seconds maximum 250C maximum. Manual Soldering: See Profile B in Supplement section. Cleaning: These devices are not process sealed. Hand clean locally using alcohol based solution. Standards & Certifications The SS series devices have not been tested for UL recognition and CSA certification. These switches are designed for use in a low-voltage, low-current circuit. When used as intended in a low-voltage, low-current circuit, the results do not produce hazardous energy. H50 www.nkkswitches.com Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles