SS314MAH4-R NKK Switches

Ultra-Miniature SMT Slides Series SS3 Distinctive Characteristics Compact dimensions and low profile allow high density mounting and close stacking of PC boards. Crisp actuation positively indicates circuit status. Heat resistant resin allows vapor phase and infrared convection reflow soldering. Award-winning STC mechanism with benefits unavailable in conventional mechanisms: smoother, positive detent actuation, increased contact stability, and unparalleled logic-level reliability. (Additional STC details in Terms and Acronyms in the Supplement section.) Insert molded terminals lock out flux, solvents, and other contaminants. Metric terminal spacing for standard PC board grid (2.0mm x 2.0mm ). H Gull-wing terminals provide mechanical stability during soldering and simplified solder joint inspection. Packaged in tape-reel or partitioned tray. Tape-reel packaging meets EIA-481-D Standard. Coplanarity: all considered surfaces must lie between two parallel planes that are a maximum distance apart of .0059 (0.15mm). (Additional coplanarity details in Terms and Acronyms in the Supplement section.) Actual Size www.nkkswitches.com H53 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers TogglesSeries SS3 Ultra-Miniature SMT Slides General Specifications Electrical Capacity (Resistive Load) Logic Level: 0.4VA maximum 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. Other Ratings Contact Resistance: 50 milliohms maximum Insulation Resistance: 100 megohms minimum 500V DC Dielectric Strength: 500V AC minimum for 1 minute minimum Mechanical Life: 10,000 operations minimum Electrical Life: 10,000 operations minimum Contact Timing: SS312S ~ Shorting (make-before-break) Total Travel: .079 (2.0mm) Materials & Finishes Actuator: Polyphenylene sulfide Housing: Phosphor bronze with tin plating (UL94V-0) Base: Polyphenylene sulfide (UL94V-0) Movable Contactor: Phosphor bronze with gold plating over silver plating (code 4) Terminals: Phosphor bronze with gold plating H Environmental Data Operating Temp Range: 25C through +85C (13F through +185F) Humidity: 90 ~ 95% humidity for 240 hours 40C (104F) Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute 3 right angled directions for 2 hours 2 Shock: 50G (490m/s ) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Installation Soldering: Reflow Soldering Recommended. See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. Cleaning: These devices are not process sealed. Hand clean locally using alcohol based solution. Standards & Certifications Flammability Standards: UL 94V-0 rated housing & base The SS3 Series slides have not been tested for UL recognition or CSA certification. These switches are designed for use in a low-voltage, low-current, logic-level circuit. When used as intended in a logic-level circuit, the results do not produce hazardous energy. H54 www.nkkswitches.com Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles