nRF24LU1+ OTP Single Chip 2.4 GHz Transceiver with USB Microcontroller and OTP Memory Product Specification v1.0 Applications Key Features nRF24L01+ compatible RF transceiver Compact USB dongles for wireless Worldwide 2.4 GHz ISM band operation peripherals Up to 2 Mbps on air data rate USB dongles for mouse, keyboards and Enhanced ShockBurst hardware link layer remotes Air compatible with nRF24LU1, nRF24LU1+, USB dongle 3-in-1 desktop bundles nRF24LE1 OTP, nRF24LE1, nRF24L01+, USB dongle for advanced media center nRF24L01, nRF2401A, nRF2402, nRF24E1 remote controls and nRF24E2 USB dongle for game controllers Low cost external 60 ppm 16 MHz crystal Toys Full speed USB 2.0 compliant device controller Up to 12 Mbps USB transfer rate 2 control, 10 bulk/interrupt and 2 ISO endpoints Dedicated 512 bytes endpoint buffer RAM Software controlled pull-up resistor for D+ PLL for full-speed USB operation Voltage regulator, 4.0 to 5.25V supply range Enhanced 8-bit 8051 compatible microcontroller Drop-in compatibility with nRF24LU1 and nRF24LU1+ except for programming Reduced instruction cycle time 32-bit multiplication-division unit 16 + 1 kbytes of on-chip OTP memory 2 kbytes of on-chip SRAM 6 general purpose digital input/output pins Hardware SPI slave and master, UART 3 16-bit timers/counters AES encryption/decryption co-processor Compact 32-pin 5x5mm QFN package All rights reserved. Reproduction in whole or in part is prohibited without the prior written permission of the copyright holder. October 2009 nRF24LU1+ OTP Product Specification Liability disclaimer Nordic Semiconductor ASA reserves the right to make changes without further notice to the product to improve reliability, function or design. Nordic Semiconductor ASA does not assume any liability arising out of the application or use of any product or circuits described herein. All application information is advisory and does not form part of the specification. Limiting values Stress above one or more of the limiting values may cause permanent damage to the device. These are stress ratings only and operation of the device at these or at any other conditions above those given in the specifications are not implied. Exposure to limiting values for extended periods may affect device reliability. Life support applications These products are not designed for use in life support appliances, devices, or systems where malfunction of these products can reasonably be expected to result in personal injury. Nordic Semiconductor ASA cus- tomers using or selling these products for use in such applications do so at their own risk and agree to fully indemnify Nordic Semiconductor ASA for any damages resulting from such improper use or sale. Data sheet status Objective product specification This product specification contains target specifications for product development. Preliminary product specification This product specification contains preliminary data supplementary data may be published from Nordic Semiconductor ASA later. Product specification This product specification contains final product specifications. Nordic Semiconductor ASA reserves the right to make changes at any time without notice in order to improve design and supply the best possible product. Contact details For your nearest dealer, please see www.nordicsemi.no Main office: Otto Nielsens veg 12 7004 Trondheim Phone: +47 72 89 89 00 Fax: +47 72 89 89 89 www.nordicsemi.no Revision 1.0 Page 2 of 178