ASL2500SHNY NXP

ASL2500SHN Two phase boost converter Rev. 3 26 October 2017 Product data sheet 1. Introduction The ASL2500SHN is a highly integrated and flexible two-phase DC-to-DC boost converter IC. It has an SPI interface allowing control and diagnostic communication with an external microcontroller. It is designed primarily for use in automotive LED lighting applications and provides an optimized supply voltage for ASLx415SHN Multi-channel LED Buck Driver. 2. General description The ASL2500SHN has a fixed frequency peak current mode control with parabolic/non-linear slope compensation. It can operate with input voltages from 5.5 V to 40 V. It can be configured via SPI for output voltages of up to 80 V, to power the LED buck driver IC. The ASL2500SHN is a two-phase converter which can have two independent outputs. The flexible driver can be configured, via the SPI interface, as a single output converter, or with multiple combinations of number of outputs and phases. The ASL2500SHN boost converter can drive up to two external low-side N channel MOSFETs from an internally regulated adjustable supply. It can drive either logic or standard level MOSFETs. The integrated SPI interface also allows for programming the supply under/over voltage range, output voltage range and DC-to-DC switching frequency. It enables the optimization of external components and flexibility for EMC design. This interface can also be used to provide diagnostic information such as the driver temperature. Additional features include input under-voltage lockout and thermal shutdown when the junction temperature of the ASL2500SHN exceeds +175 C. The device is housed in a very small HVQFN32 pin package with an exposed thermal pad. It is designed to meet the stringent requirements of automotive applications. It is fully AEC Q100 grade 1 qualified. It operates over the 40 C to +125 C ambient automotive temperature range.ASL2500SHN NXP Semiconductors Two phase boost converter 3. Features and benefits The ASL2500SHN is an automotive grade product that is AEC-Q100 grade 1 qualified. Operating ambient temperature range of 40 C to +125 C Wide operating input voltage range from +5.5 V to +40 V Output voltage programmable via SPI interface Multi-phase operation for higher power Up to two phases per output Up to two flexible output voltages with 3 % accuracy programmable via SPI Both output voltages can be controlled independently Fixed Frequency Operation via built-in oscillator Slope compensation to track the frequency and output voltage Programmable control loop compensation Fast high efficiency FET switching Programmable internal gate driver voltage regulator Gate switching is halted when overvoltage on output is detected Support both Logic Level and Standard Level FETs Low Electro Magnetic Emission (EME) and high Electro Magnetic Immunity (EMI) Output voltage monitoring Supply voltage measurement Control signal to enable the device Read-back programmed voltage and frequency range via SPI Junction temperature monitoring via SPI Small package outline HVQFN32 Low quiescent current <5 A at 25 C when EN = 0 4. Applications Automotive LED lighting Daytime running lights Position or park light Low beam High beam Turn indicator Fog light Cornering light 5. Ordering information Table 1. Ordering information Type number Package Name Description Version ASL2500SHN HVQFN32 plastic thermal enhanced very thin quad flat package no leads 32 terminals SOT617-12 body 5 5 0.85 mm ASL2500SHN All information provided in this document is subject to legal disclaimers. NXP Semiconductors N.V. 2017. All rights reserved. Product data sheet Rev. 3 26 October 2017 2 of 39