NXP Semiconductors Document Number: MC06XS4200 Rev. 5.0, 5/2018 Data Sheet: Advance Information Dual 24 V, 6.0 mOhm high-side 06XS4200 switch The 06XS4200 device is part of a 24 V dual high-side switch product family with integrated control and a high number of protective and diagnostic functions. It has been designed for truck, bus, and industrial applications. The low R DS(on) High-side switch channels (<6.0 mOhm) can control different load types bulbs, solenoids, or DC motors. Control, device configuration, and diagnostics are performed through a 16-bit serial peripheral interface (SPI), allowing easy integration into existing applications. Both channels can be controlled individually by external/internal clock-signals or by direct inputs. Using the internal clock allows fully autonomous device operation. Programmable output voltage slew rates (individually programmable) help improve EMC performance. To avoid shutting off the device during inrush current, while still being able to closely track the load current, a dynamic overcurrent threshold profile is featured. Switching current of each channel can be sensed with a programmable sensing ratio. Whenever communication with the external microcontroller is lost, the device enters a fail-safe operation mode, but remains operational, controllable, and protected. This device is powered using SMARTMOS technology. FK SUFFIX (PB-FREE) 98ASA00428D Features 23 PIN PQFN (12 X 12 mm) Two fully-protected 6.0 mOhm ( 25 C) high-side switches Up to 12 A steady-state current per channel Separate bulb and DC motor latched overcurrent handling Parallel output operating mode with improved switching synchronization Individually programmable internal/external PWM clock signals (switching frequency, duty cycle, slew rate, switch-on time-shift) Overcurrent, short-circuit, and overtemperature protection with programmable auto-retry functions Accurate temperature and current sensing (high/low sensing ratios/offset compensation) Openload detection (channel in OFF and ON state), also for LED applications (7.0 mA typ.) Normal operating range: 8.0 to 36 V, extended range: 6.0 to 58 V, 3.3 V and 5.0 V compatible 16-bit SPI port for device control, configuration, and diagnostics at rates up to 8.0 MHz V V V DD DD PWR 06XS4200 VDD VPWR I/O CLOCK I/O FSB SCLK SCLK HS0 CSB CSB LOAD SI SO MCU I/O RSTB SO SI HS1 I/O IN0 LOAD M I/O IN1 CONF0 CONF1 I/O FSOB A/D SYNC A/D CSNS GND GND Figure 1. Simplified application diagram * This document contains certain information on a new product. Specifications and information herein are subject to change without notice. NXP B.V. 2018.Table of Contents 1 Orderable parts 3 2 Internal block diagram . 4 3 Pin connections 5 4 Electrical characteristics . 7 4.1 Maximum ratings . 7 4.2 Static electrical characteristics 9 4.3 Dynamic electrical characteristics . 15 4.4 Timing diagrams 22 5 Functional description 25 5.1 Introduction 25 5.2 Pin assignment and functions 25 5.3 Functional internal block description . 28 6 Functional device operation 29 6.1 Operation and operating modes 29 6.3 Logic commands and SPI registers . 48 7 Typical applications 57 8 Packaging . 59 8.3 Package mechanical dimensions . 59 9 Revision history . 68 06XS4200 NXP Semiconductors 2