MC33931VWR2 NXP

Document Number: MC33931 Freescale Semiconductor Rev. 4.0, 10/2012 Technical Data 5.0 A Throttle Control H-bridge 33931 The 33931 is a monolithic H-Bridge Power IC in a robust thermally enhanced package. It is designed primarily for automotive electronic throttle control, but is applicable to any low voltage DC servo motor control application within the current and voltage limits stated in this THROTTLE CONTROL H-BRIDGE specification. The 33931 H-Bridge is able to control inductive loads with currents up to 5.0 A peak. RMS current capability is subject to the degree of heatsinking provided to the device package. Internal peak-current limiting (regulation) is activated at load currents above 6.5 A 1.5 A. Output loads can be pulse-width modulated (PWM-ed) at frequencies up to 11 kHz. A load current feedback feature provides a proportional (0.24% of the load current) current output suitable for monitoring by a VW SUFFIX (PB-FREE) EK SUFFIX (PB-FREE) microcontrollers A/D input. A Status flag output reports under-voltage, 98ARH98330A 98ARL10543D over-current, and over-temperature fault conditions. 44-PIN HSOP 32-PIN SOICW-EP WITH PROTRUDING Two independent inputs provide polarity control of two half-bridge HEAT SINK totem-pole outputs. The disable inputs are provided to force the H- bridge outputs to tri-state (high-impedance off-state). ORDERING INFORMATION Features Device Temperature 5.0 to 28 V continuous operation (transient operation from 5.0 to (Add R2 Suffix for Package Range (T ) A 40 V) Tape and Reel) 235 m maximum R T =150 C (each H-bridge DS(ON) J MC33931VW 44 HSOP MOSFET) -40 to 125C MC33931EK 32 SOICW-EP 3.0 V and 5.0 V TTL / CMOS logic compatible inputs Over-current limiting (regulation) via internal constant-off-time PWM Output short-circuit protection (short to VPWR or GND) Temperature-dependant current-limit threshold reduction All inputs have an internal source/sink to define the default (floating input) states Sleep mode with current draw < 50 A V V PWR DD 33931 SF VPWR FB CCP OUT1 IN1 MOTOR MCU IN2 OUT2 D1 EN/D2 PGND AGND Figure 1. MC33931 Simplified Application Diagram Freescale Semiconductor, Inc., 2008-2012. All rights reserved.INTERNAL BLOCK DIAGRAM INTERNAL BLOCK DIAGRAM VPWR VDD LOGIC SUPPLY VCP CHARGE HS1 HS2 CCP PUMP OUT1 TO GATES OUT2 HS1 LS1 LLSS22 IN1 LS1 IN2 HS2 PGND EN/D2 LS2 GATE DRIVE AND D1 PROTECTION VSENSE LOGIC CURRENT MIRROR SF AND ILIM PWM CONSTANT OFF-TIME FB PWM CURRENT REGULATOR AGND PGND Figure 2. 33931 Simplified Internal Block Diagram 33931 Analog Integrated Circuit Device Data 2 Freescale Semiconductor