PN7120A0EV/C10801Y NXP

PN7120 NFC controller with integrated firmware, supporting all NFC Forum modes Rev. 3.5 11 June 2018 Product data sheet 312435 COMPANY PUBLIC 1 Introduction This document describes the functionality and electrical specification of the NFC Controller PN7120. Additional documents describing the product functionality further are available for design- in support. Refer to the references listed in this document to get access to the full for full documentation provided by NXP. In this document the term MIFARE Classic card refers to a MIFARE Classic IC-based contactless card.NXP Semiconductors PN7120 NFC controller with integrated firmware, supporting all NFC Forum modes 2 General description PN7120, the best plug n play full NFC solution - easy integration into any OS environment, with integrated firmware and NCI interface designed for contactless communication at 13.56 MHz. It is the ideal solution for rapidly integrating NFC technology in any application, especially those running OS environment like Linux and Android, reducing Bill of Material (BOM) size and cost, thanks to: full NFC forum compliancy (see 11 ) with small form factor antenna embedded NFC firmware providing all NFC protocols as pre-integrated feature 2 direct connection to the main host or microcontroller, by I C-bus physical and NCI protocol ultra-low power consumption in polling loop mode Highly efficient integrated power management unit (PMU) allowing direct supply from a battery PN7120 embeds a new generation RF contactless front-end supporting various transmission modes according to NFCIP-1 and NFCIP-2, ISO/IEC 14443, ISO/IEC 15693, ISO/IEC 18000-3, MIFARE Classic IC-based card and FeliCa card specifications. It embeds an ARM Cortex-M0 microcontroller core loaded with the integrated firmware supporting the NCI 1.0 host communication. The contactless front-end design brings a major performance step-up with on one hand a higher sensitivity and on the other hand the capability to work in active load modulation communication enabling the support of small antenna form factor Supported transmission modes are listed in Figure 1. For contactless card functionality, the PN7120 can act autonomously if previously configured by the host in such a manner. PN7120 integrated firmware provides an easy integration and validation cycle as all the NFC real-time constraints, protocols and device discovery (polling loop) are being taken care internally. In few NCI commands, host SW can configure the PN7120 to notify for card or peer detection and start communicating with them. NFC FORUM READER CARD NFC-IP MODES (PCD - VCD) (PICC) READER FOR NFC FORUM ISO/IEC 14443 A ISO/IEC 14443 A TAG TYPES 1 TO 4 ISO/IEC 14443 B ISO/IEC 14443 B P2P ACTIVE 106 TO 424 kbps ISO/IEC 15693 INITIATOR AND TARGET MIFARE CLASSIC 1K / 4K P2P PASSIVE 106 TO 424 kbps MIFARE DESFire INITIATOR AND TARGET (1) Sony FeliCa aaa-015868 1. According to ISO/IEC 18092 (Ecma 340) standard. Figure 1.PN7120 transmission modes PN7120 All information provided in this document is subject to legal disclaimers. NXP B.V. 2018. All rights reserved. Product data sheet Rev. 3.5 11 June 2018 COMPANY PUBLIC 312435 2 / 58