NXCIF210 Omron

NX-series Communications Interface Units NX-CIF CSM NX-CIF DS E 8 1 Provides simplicity and flexibility in connecting serial devices to EtherCAT Mount to the NX-series EtherCAT Coupler Unit and connect various types of serial devices. The serial line monitor on the Sysmac Studio helps easily and reliably connect serial devices. Features Just 12 mm wide, saving space in your cabinet. Three models are available with a choice of one RS-422A/485, one RS-232C, or two RS-232C ports. Screwless push-in terminal block (1-port model) and D-Sub connector (2-port model) significantly reduce wiring work. No-protocol communications are supported as the communications protocol. The maximum baud rate is 230.4 kbps. The baud rate can be selected to match the connected serial devices. The settings are backed up and saved in the EtherCAT Coupler Unit. This facilitates commissioning and maintenance. The serial line monitor enables you to check the communications status with serial devices on the Sysmac Studio for easy and reliable startup of the devices. System Configuration System Configuration in the Case of a CPU Unit The following figure shows a system configuration when a group of NX Units is connected to an NX-series CPU Unit. Sysmac Studio CPU Rack Support Software NX-series CPU Unit NX1P2- Connection to built-in TM EtherNet/IP port Built-in EtherCAT port End Cover NX Units Communications Serial line Interface Units Serial Communications Device EtherCAT Slave Terminal EtherCAT NX Units EtherCAT Coupler Unit Sysmac is a trademark or registered trademark of OMRON Corporation in Japan and other countries for OMRON factory automation products. EtherCAT is a registered trademark of Beckhoff Automation GmbH for their patented technology. TM EtherNet/IP is the trademarks of ODVA. Other company names and product names in this document are the trademarks or registered trademarks of their respective companies. 1NX-CIF System Configuration of Slave Terminals The following figure shows an example of the system configuration when an EtherCAT Coupler Unit is used as a Communications Coupler Unit. Sysmac Studio EtherCAT master *2 Support Software NJ/NX-series CPU Unit, NY-series Industrial PC, or master from another manufacturer Connection to peripheral USB port TM or built-in EtherNet/IP port on CPU Unit or Industrial PC *1 .xml ESI files Built-in EtherCAT port EtherCAT Slave Terminal Sysmac Studio Support Software Communications cable NX Series Ethernet cables EtherCAT Coupler Unit NX-ECC Peripheral USB port. Connection to peripheral USB port on EtherCAT Coupler Unit .xml ESI files End Cover NX Units Serial line Communications Interface Units Serial Communications Device *1. The connection method for the Sysmac Studio depends on the model of the CPU Unit or Industrial PC. *2. An EtherCAT Slave Terminal cannot be connected to any of the OMRON CJ1W-NC 81/ 82 Position Control Units even though they can operate as EtherCAT masters. Note: For whether NX Units can be connected to the CPU Unit or Communications Coupler Unit to be used, refer to the version information. 2