Ordering number: ENA0907B LV8013T Bi-CMOS IC Forward/Reverse Motor Driver LV8013T Allowable Operating Conditions at Ta = 25C, SGND = PGND = 0V Parameter Symbol Conditions Ratings Unit Supply voltage (For load) VM 2.0 to 15.0 V Supply voltage (For control) V 2.7 to 5.5 V CC Input signal voltage V 0 to V V IN CC Input signal frequency f max Duty = 50% 200 kHz Capacitor for charge pump C1, C2, 0.001 to 0.1 F CVG1, CVG2 Electrical Characteristics at Ta = 25C, V = 5.0V, VM = 12.0V, SGND = PGND = 0V, unless especially specified. CC Ratings Re- Parameter Symbol Conditions Unit marks min typ max Supply current for load at IM1 EN = 0V 1 1.0 A standby 1 Supply current for load at IM2 V = 0V, Each input = 0V 1 1.0 A CC standby 2 Supply current for control at ICO EN = 0V, IN1 = IN2 = 0V 2 12.5 25 50 A standby Current drain during operation 1 IC1 V = 3.3V, EN = 3.3V, VG at no load 3 0.6 1.0 mA CC Current drain during operation 2 IC2 V = 5.0V, EN = 5V, VG at no load 3 0.7 1.2 mA CC H-level input voltage V 2.7V V 5.5V 0.6V V V IH CC CC CC L-level input voltage V 2.7V V 5.5V 0 0.2V V IL CC CC H-level input current I V = 5V 4 12.5 25 50 A IH IN (IN1, IN2, TIN) L-level input current I V = 0V 4 -1.0 A IL IN (IN1, IN2, TIN) Pull-up resistance (EN) RUP 4 100 200 400 k Pull-down resistance RDN 4 100 200 400k (EN) Output ON resistance RON Sum of ON resistances at top and 5 0.3 0.5 bottom Charge pump voltage1 VG1 V 2 - 5.4V CLAMP circuit 6 5.15 5.4 5.65 V CC Charge pump voltage2 VG2 VM + VG1 Voltage raising circuit 6 17.1 17.4 17.6 V Low-voltage detection operation VCS V voltage 7 2.1 2.25 2.4 V CC voltage Thermal shutdown operation Tth Design guarantee 8 150 180 210 C temperature Charge pump capacity 1 VG1LOAD IG1 = 500A 9 5.05.3 V Charge pump capacity 2 VG2LOAD IG2 = 500A 9 16.016.5 V IG current dissipation IG 10 350 A (Fin = 20kHz) Charge pump start time TVG CVG = 0.1F 11 1.0ms Output Turn on time TPLH 12 0.5 1.0 s block Turn off time TPHL 12 0.5 1.0 s TOUT Turn on time TON C = 500pF 12 0.5 20 s Turn off time TOFF C = 500pF 12 0.5 20 s TOUT output voltage H TOH C = 500pF VG2-0.1 VG2 V TOUT output voltage L TOL C = 500pF 0.05 0.1 V * Design guarantee : This characteristics is not measured. Refer to next page for remarks. No.A0907-2/6