Ordering number : ENA1382B LV8406T Bi-CMOS IC 2ch Forward/Reverse Motor Driver LV8406T Allowable Operating Conditions at Ta = 25C, SGND = PGND = 0V Parameter Symbol Conditions Ratings Unit Power supply voltage (VM pin) VM 1.5 to 15.0 V Power supply voltage (V pin) V 2.8 to 5.5 V CC CC Input signal voltage V 0 to V V IN CC Input signal frequency f max 200 kHz Electrical Characteristics Ta = 25C, V = 3.0V, VM = VS = 6.0V, SGND = PGND = 0V, unless otherwise specified. CC Ratings Parameter Symbol Conditions Remarks Unit min typ max Standby load current drain IMO EN = 0V 1 1.0 A Standby control current drain ICO EN = IN1 = IN2 = IN3 = IN4 = 0V 2 1.0 A Standby load current drain2 IMO2 V = 0V, VM = VS = 6V 1.0 A CC Operating control current drain IC1 EN = 3V, with no load 3 0.85 1.2 mA High-level input voltage V 2.7 V 5.5V 0.6V V V IH CC CC CC Low-level input voltage V 2.7 V 5.5V 0 0.2V V IL CC CC High-level input current I1 V = 3V 4 15 25 A IH IN (EN1, EN2, IN1, IN2, IN3, IN4) Low-level input current I1 V = 0V 4 -1.0 A IL IN (EN1, EN2, IN1, IN2, IN3, IN4) Pull-down resistance value RDN EN1, EN2, IN1, IN2, IN3, IN4 100 200 400 k Charge pump voltage VG V + VS 8.5 9.0 9.5 V CC Output ON resistance 1 RON1 Sum of top and bottom sides ON 5 0.75 1.2 resistance. Output ON resistance 2 RON2 Sum of top and bottom sides ON 5 1.0 1.5 resistance. V = 2.8V CC Low-voltage detection voltage VCS V pin voltage is monitored 6 2.15 2.30 2.45 V CC Thermal shutdown temperature Tth Design guarantee value * 7 150 180 210 C Output block Turn-on time TPLH 8 0.2 0.4 S Turn-off time TPHL 8 0.2 0.4 S * : Design guarantee value and no measurement is preformed. Remarks 1. Current consumption when output at the VM pin is off. 2. Current consumption when the V pin when in standby mode. CC 3. Current consumption at the V pin when EN is 3V (standby mode). CC 4. Pins EN1, 2, IN1, 2, 3, and 4 are all pulled down. 5. Sum of upper and lower saturation voltages of OUT pin divided by the current. 6. All power transistors are turned off if a low V condition is detected. CC 7. All output transistors are turned off if the thermal protection circuit is activated. They are turned on again as the temperature goes down. 8. Rising time from 10 to 90% and falling time from 90 to 10% are specified. No.A1382-2/6