STK672-120-E ON Semiconductor

Ordering number : EN6042A STK672-120-E Thick-Film Hybrid IC STK672-120-E Specifications Maximum Ratings at Tc = 25C Parameter Symbol Conditions Ratings Unit Maximum supply voltage 1 V max No signal 52 V CC Maximum supply voltage 2 V max No signal -0.3 to +7.0 V DD Input voltage V max Logic input pins -0.3 to +7.0 V IN Output current I max V = 5V, CLOCK 200Hz 4.0 A OH DD Repeated avalanche capacity Ear max 36 mJ Allowable power dissipation Pd max With an arbitrarily large heat sink. Per MOSFET 8.5 W Operating substrate temperature Tc max 105 C Junction temperature Tj max 150 C Storage temperature Tstg -40 to +125 C Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability. Allowable Operating Ranges at Ta = 25C Parameter Symbol Conditions Ratings Unit Maximum supply voltage 1 V With signals applied 10 to 42 V CC Maximum supply voltage 2 V With signals applied 5.0 5% V DD Input voltage V 0 to V V IH DD Output current 1 I 1 Tc = 105C, CLOCK 200Hz 2.4 A OH Tc = 80C, CLOCK 200Hz Output current 2 I 2 3.0 A OH See the motor curren (I ) derating curve OH Clock frequency f Minimum pulse width: 20s 0 to 25 kHz CL Phase driver withstand voltage V I = 1mA (Tc = 25C) 100 min V DSS D Electrical Characteristics at Tc = 25C, V = 24V, V = 5V CC DD Rating Parameters Symbols Conditions unit min typ max V supply current I CLOCK = GND 2.6 6mA DD CCO With R/L = 3/3.8mH in each phase Output average current Ioave 0.56 0.62 0.69 A Vref = 0.176V FET diode forward voltage Vdf If = 1A (R = 23) 1.1 1.7 V L Output saturation voltage Vsat R = 23 0.4 0.56 V L High-level input voltage V Pins 6 to 9 (4 pins) 4.0 V IH Low-level input voltage V Pins 6 to 9 (4 pins) 1.0V IL With pins 6 to 9 at the ground level. Input current I 62 125 250 A IL Pull-up resistance: 40k (typical) Vref input voltage V Pin 12 0 3.5V rH Vref input bias current I With pin 12 at 1V 50 500nA IB Note: A fixed-voltage power supply must be used. Package Dimensions unit:mm (typ) 4167 46.6 8.5 41.2 3.6 1 12 2.0 0.5 0.4 11 2=22 (9.6) 2.9 No.6042-2/9 12.7 25.5 4.0 1.0