OSM5XME1E1E Optosupply

Xeon 1 Power Warm White LED Xeon 1 Power Warm White LED OSM5XME1E1E VER C.0 Features Outline Dimension Highest Luminous Flux Super Energy Efficiency 3.6 Long Lifetime Operation Superior ESD protection Superior UV Resistance Applications BackView Read lights (car, bus, aircraft) Anode Cathode Portable (flashlight, bicycle) Bollards / Security / Garden ESD Protection Diode Unit:mm Traffic signaling / Beacons Tolerance:0.30mm In door / Out door Commercial lights Automotive Ext Absolute Maximum Rating ((((TTTTaaaa====22225555)))) Directivity Item Symbol Value Unit 0 DC Forward Current I 400 mA F Pulse Forward Current* I 500 mA FP Reverse Voltage V 5 V R Power Dissipation P 1600 mW D 0 Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40~ +100 Lead Soldering Temperature Tsol - 260/5sec *Pulse width Max.10ms Duty ratio max 1/10 Electrical -Optical Characteristics ((TTaa==2255)) ((TTaa==2255)) Forward Operating Current (DC) Item Symbol Condition Min. Typ. Max. Unit 400 350 DC Forward Voltage V I =350mA 3.0 3.3 4.0 V F F 300 DC Reverse Current I V =5V - - 10 A 250 R R 200 RJ-A=60/W v Luminous Flux I =350mA 80 90 - lm F 150 RJ-A=50/W RJ-A=40/W 100 Color Temperature CCT I =350mA - 3000 - K F RJ-A=30/W 50 0 x I =350mA - 0.45 - - Chromaticity F 0 25 50 75 100 125 Coordinates* y I =350mA - 0.41 - - F Ambient Temperature, TA () 50% Power Angle 21/2 I =350mA - 140 - deg F Note: Dont drive at rated current more than 5s without heat sink for Xeon 1 emitter series. LED & Application Technologies Forward Current, IF (mA)Xeon 1 Power Warm White LED Xeon 1 Power Warm White LED OSM5XME1E1E VER C.0 Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. The LEDs should only be picked up by making contact with the sides of the LED body. Avoid touching the silicone lens especially by sharp tools such as Tweezers. Avoid leaving fingerprints on the silicone lens. Please store the LEDs away from dusty areas or seal the product against dust. When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies