Xeon 1 Power PPuurree GGrreeeenn &&RReedd && BBlluuee LLEEDD OSTCXBEAC1E Features Outline Dimension 4.4 Highest Luminous Flux 5.3 3 2 1 1.0 Super Energy Efficiency 2.75 Long Lifetime Operation 5 . 3 Superior ESD protection 0 . 4 . 7 1 5 6 Superior UV Resistance 0.2 Red Anode Mark Water Clear Type 4 Applications 5 6 Back View 1 3 2 Mobile Phone Flash Automotive Interior/Exterior Lighting / Signal Lighting 4 ,5,6 .Anod e B R G 1,2 ,3.Cathod e Architectural Lighting Unit:mm LCD TV / Monitor Backlight Toleran ce0.3 0mm 4 6 Projector Light Source / Traffic Signals / Task Lighting 5 Decorative / Pathway Lighting / Household Applications Directivity Absolute Maximum Rating (Ta=25)) )) Value 0 Item Symbol Unit Red Green/Blue DC Forward Current I 400 400 mA F Pulse Forward Current* I 500 500 mA FP Reverse Voltage V 5 5 V R Power Dissipation P 1200 1600 mW D 0 Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40 ~ +100 Lead Soldering Temperature Tsol - 260/5sec *Pulse width Max.10ms Duty ratio max 1/10 Electrical -Optical Characteristics (Ta=25)) )) Item Symbol Condition Min. Typ. Max. Unit V (R) I =350mA 2.0 2.5 3.0 V F F DC Forward Voltage V (B/G) I =350mA 3.0 3.3 4.0 V F F DC Reverse Current I V =5V - - 10 A R R (Red) I =350mA 620 625 630 nm D F Domi. Wavelength (Green) I =350mA 520 525 535 nm D F (Blue) I =350mA 455 460 465 nm D F v (Red) I =350mA 40 50 - lm F v (Green) Luminous Flux I =350mA 50 70 - lm F v (Blue) I =350mA 15 20 - lm F 50% Power Angle 21/2 I =350mA - 120 - deg F Note: Dont drive at rated current more than 5s without heat sink for Xeon 1 Power emitter series. LED & Application Technologies Xeon 1 Power PPuurree GGrreeeenn &&RReedd && BBlluuee LLEEDD OSTCXBEAC1E Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. The LEDs should only be picked up by making contact with the sides of the LED body. Avoid touching the silicone lens especially by sharp tools such as Tweezers. Avoid leaving fingerprints on the silicone lens. Please store the LEDs away from dusty areas or seal the product against dust. When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies