HD Flex Patch Panel Part Numbers: FLEX1UPN**, FLEX2UPN**, FLEX4UPN** Panduit Corp. 2018 INSTALLATION INSTRUCTIONS FS128B Note: HD Flex Patch Panels are compatible with HD Flex Fiber System Components. HD Flex may not be compatible with other systems and is not recommended. FLEX1UPN** FLEX2UPN** FLEX4UPN** ** denotes 04, 06, or 12 CONTENTS: ( ) indicates FLEX4UPN** quantity 1 - Patch Panel 4 (8) - 12-24 x 1/2 screws 4 (8) - M x 1.0 x 15mm screws WARNING: UNMATED CONNECTORS MAY EMIT INVISIBLE LASER RADIATION. DO NOT LOOK DIRECTLY INTO THE END OF THE CONNECTOR. DO NOT INSPECT WITH MAGNIFYING DEVICES. MAINTAIN DUST CAPS ON UNMATED CONNECTORS. CAUTION: Fiber optic cable is sensitive to excessive pulling, bending, and crushing forces. Consult the manufacturers cable specification sheet for the specific cable in use. Follow TIA/EIA-568-A, 569, 606, and 607 installation guidelines where applicable. Care should be taken when opening or closing a fully loaded drawer in order to protect the fiber components. ASSEMBLY VIEW (FLEX1UPN** shown) Cassettes or FAPs: (sold separately) Optional Trunk Slack Plate FLEX-PLATE1U (sold separately) 1RU HD Flex Patch Panel Optional P/N: FLEX1UPNO6 1RU Front Cable Manager P/N: FLEX-FCM1UA (sold separately) Figure 1 For Technical Support: www.panduit.com/resources/install maintain.asp Page 1 of 16 Panduit Corp. 2018 INSTALLATION INSTRUCTIONS FS128B Rack Mounting If RU space is open above patch panel location, partially install two screws, one on each side of the rack. These partially installed screws will assist in mounting the patch panel to the rack. For all patch panels pre-install two screws in the bottom hole location of the rack position desired. If RU space is not open above patch panel location, do not pre-install screws. Place patch panel into position and secure with a minimum of four screws. 2RU 1RU Figure 2 For the pre-installed screws mounting method, place patch panel into rack and allow patch panel mounting brackets to rest on the partially installed screws. Install the remaining screws and tighten all to secure the enclosure. Use a minimum of four screws. Figure 3 For Technical Support: www.panduit.com/resources/install maintain.asp Page 2 of 16