PA25282A01 Rev. 00 8-2007 KMTRTH and KMTRTLS MTRTH and MTRTLS TOOL CHANGEOVER KITS INSTALLATION INSTRUCTIONS Panduit Corp. 2007 CHANGEOVER KITS: Changeover kit allows for installation of heavy (H) cross-section MRT and MRS style ties KMTRTH in MTRTLS tool. Kit comes complete with one setshear finger (H), one anvil (H), three screws, thread-lock tube and installation instructions. Changeover kit allows for installation of standard (S) and light-heavy (LH) cross-section KMTRTLS MRT and MRS style ties in MTRTH tool. Kit comes complete with one setshear finger (LS), two anvils (LH and S), three screws, thread-lock tube and installation instructions. SAFETY PRACTICES ALWAYS wear safety glasses when using this tool. DO NOT place fingers near cutting blade during tool actuation. Fingers may be pinched or injured by cutter blade. DO NOT use tool on live electrical sources. TO REPLACE ANVIL Remove two screws holding Anvil onto the tool. A 3/32 Allen Wrench will be required. The screws may be very tight as they have been installed with Loctite . Once the screws are removed, slide the Anvil towards the front of the tool and downward away from the tool. Set aside old Anvil. ** Place new Anvil onto bottom of the tool. The Anvil must straddle the two plates and have the slots toward the rear. When the Anvil is slid backwards, the slots must engage the pins. If done correctly, the hole on each side of the Anvil will align with a tapped mounting hole below. Replace the screws applying a drop of Loctite to each screw. See pictures below. ** IF SETSHEAR FINGER IS TO BE REPLACED AS WELL, NOW IS THE TIME TO REPLACE PER THE INSTRUCTIONS BELOW. TO REPLACE SETSHEAR FINGER Remove a single screw holding the Setshear Finger up onto the Sliding Detent Assembly. Use a 1/16 Allen Wrench to remove the screw. The screw may be tight as it has been installed with Loctite . Once the screw is removed, slide the Setshear Finger toward the front of the tool. This should disengage it from the Sliding Detent Assembly. Pull the Finger down out of the bottom of the tool. Installation is the reverse of these steps. When replacing the Setshear Finger, the notch on the flat surface of the finger must engage the retaining tab on the Sliding Detent Assembly. See pictures below. WHEN COMPLETE, THE LOCATING SET SCREW ON THE FRONT OF THE TOOL WILL NEED TO BE ADJUSTED PRIOR TO TOOL USE. The above names and products are the registered trademarks of their respective corporations. Technical Support: Website: www.panduit.com See Page 4 for contact E-mail: cs panduit.com information. Page: 1 of 4 KMTRTH and KMTRTLS OPERATION INSTRUCTIONS SIDE PLATE REMOVED FOR CLARITY Pins (2) Each Side Setshear Finger Anvil Anvil Mounting Screw Finger Mounting (Each Side) Retaining Tab Screw INSTALLATION OF ANVIL OR SETSHEAR FINGER TO REPLACE ANVIL OR SETSHEAR FINGER: NOTE: Replace or install Anvil or Setshear Finger per table below. MTRTH TOOL MTRTLS TOOL HEAVY STANDARD LIGHT HEAVY ANVIL MARKS 0 1 2 SETSHEAR 1 2 2 FINGER MARKS SETSHEAR FINGER DIFFERENTIATION Identifying Marks Heavy Ties * 1 Mark Standard / Light Heavy Ties * 2 Marks - MTRTH Tool - - MTRTLS Tool - Page: 2 of 4