VS-AVT-RKBB4 Panduit

VeriSafe AVT Knowledge Base Topics General Product Information Will voltage be present on the door when VeriSafe is installed Does the VeriSafe AVT have internal short circuit protection How should the VeriSafe AVT be disposed of at end of life Does the VeriSafe AVT device have digital integrated circuitry What is the absence of voltage threshold Does the AVT detect ground faults Does VeriSafe detect stray or inductive voltage in the 0-50V range Is the device protected from static electricity Is the VeriSafe Absence of Voltage Tester protected from power surges What is the expected product life of the VeriSafe AVT Can VeriSafe be used in an outdoor environment application Installation/System Requirements Is overcurrent protection required for the VeriSafe Absence of Voltage Tester Will installation of VeriSafe Absence of Voltage Tester affect the short circuit current rating (SCCR) of my equipment Can the VeriSafe Absence of Voltage Tester be installed on a single phase system Can the VeriSafe Absence of Voltage Tester be installed on a DC system Will the VeriSafe AVT detect improper installation Can the AVT be installed to monitor the output of a Variable Frequency Drive (VFD) Can VeriSafe be retrofit into existing equipment Will this void the UL listing Should the VeriSafe AVT device be installed on the Line side or Load side of the equipment disconnect Is it acceptable to use a single VeriSafe AVT device on a main panel to provide absence of voltage protection for downstream panels PANDUIT FOR PUBLIC USE March 7, 2018 How should the VeriSafe AVT device be connected to a DC system Does VeriSafe operate differently on solidly grounded and high resistance grounded systems How does the VeriSafe AVT satisfy the NEC tap rule What is the withstand rating of the AVT What is the impedance rating of the AVT Can the VeriSafe AVT be used on 4-pole systems Operation Does the AVT distinguish between single-, two-, and three-phase systems Does the VeriSafe Absence of Voltage Tester verify it is operating satisfactorily before and after verifying the absence of voltage Why does the yellow Caution Indicator flash at the end of a failed test procedure Is PPE required to initiate an absence of voltage test with the VeriSafe Absence of Voltage Tester Is PPE required to open an enclosure if the VeriSafe Absence of Voltage Tester confirms the absence of voltage (green light) How does the VeriSafe Absence of Voltage Tester verify that sensor leads are in contact with phase conductors and ground Will VeriSafe indicate the difference between residual voltage and nominal voltage How would an operator know if nominal voltage is detected Are users protected from hazardous voltage when using the AVT Does the VeriSafe AVT device search for stored energy in VFDs, capacitors, or UPS devices How do you know that the test circuit is working Does VFD or MCC noise affect the device Can VeriSafe be used to ensure that energy stored in the capacitors in a variable frequency drive (VFD) has dissipated What is the known voltage source used to verify that the VeriSafe Absence of Voltage Tester is operating satisfactorily What happens if VeriSafe is exposed to temperatures beyond its max rating of 60 C Will VeriSafe stop working How will it react Standards & Ratings PANDUIT FOR PUBLIC USE March 7, 2018