PDA080W-48VG-R Phihong

WWW.PHIHONG.COM 80W Constant Voltage LED Driver PDA080 Series for Outdoor Lighting Features High Efficiency IP67 - waterproof, Potted Class 2 per UL1310 Wide Operating Temperature Range 5 Year Warranty Brownout/Brownout Recovery OVP, Short and Open Circuit Protection 120V-277V AC Operation Applications General Lighting Outdoor Lighting Street Lighting Architectural Lighting Safety Approvals CE cUL/UL Mechanical Characteristics Length: 241mm (9.5in) Height: 30.5mm (1.2in) Width: 43mm (1.7in) Weight: 750g (1.65lbs) Output Specifications Output Current Output (1) Model Output Voltage (2) Min. Typ. Max. Power PDA080X-48VG 48V 0A 1.67A 1.70A 80W Note (1): X is B for non-dimming or W for 0-10V Dimming Note (2): Output power derated to 72W when input voltage is <100VAC Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revised 11/6/2013 PDA080X Characteristics WWW.PHIHONG.COM Input: Dimming Grounding AC Input Voltage Rating Dim(-) and Vout(-) must never be connected together to 90VAC to 304VAC ensure proper operation and isolation requirements AC Input Frequency EMC 47~63Hz EN55015/CISPR 15, FCC 47 CFR Part 15/18, Class A Maximum Input Current Immunity 2A IEC61000-4-2 IEC61000-4-3 Leakage Current IEC61000-4-4 0.5mA maximum at 230VAC Input IEC61000-4-5* IEC61000-4-6 Inrush Current IEC61000-4-8 20A IEC61000-4-11 IEC61000-3-2 Class C OUTPUT: *Surge Differential mode: 2.0kV, Common mode: 4.0kV Power Factor 0.9 at nominal Ring Wave Surge (ANSI C62.41.2 Cat A) Differential mode: 4.0kV Ripple and Noise Common mode: 6.0kV <7% (p-p) Input Over Current Protection Efficiency (Target) The input power line will be fused with a 3.15A fuse 87% at 277VAC 85% at 120VAC Short-Circuit Protection The PSU will withstand a short circuit across the Turn-on Delay Time outputs without damage 0.5s maximum at nominal AC Power ON Open Circuit Protection Environmental: Once the circuit is opened, the output voltage should be Temperature less than 120% at nominal AC input conditions Operation -40 to +60C Non-operation -40 to +85C Dielectric Withstand (Hi-pot) Test Primary to secondary: 4242VDC for 1 minute, 5mA Operating Humidity 10 to 95% Insulation Resistance Case Temperature Primary to secondary: >5M Ohm 500VDC, 1 Minute 80C maximum Design Life Warranty 50K hours at full power, ambient 50C and Tcase <rating 5 Years Wire Connections Dimming Function: (W Models) Position Terminal Color Specification Dimming Control Line Black AWG18 solid wire 0-10VDC Neutral White AWG18 solid wire Ground Green/Yellow AWG18 solid wire Dimming Output to Load Vout+ Red AWG18 solid wire PWM at 500Hz Vout- Blue AWG18 solid wire Dim+ Violet AWG18 Solid wire Dim- Grey AWG18 Solid Wire