1SD536F2 Data Sheet 1SD536F2-FZ2400R12KE3 Single-Channel SCALE Plug-and-Play IGBT Driver Ultra-compact, high-performance driver for 2-level, 3-level and multilevel converters Abstract The SCALE plug-and-play driver 1SD536F2-FZ2400R12KE3 is an ultra- compact single-channel intelligent gate driver designed for Infineons high- power IGBTs of type FZ2400R12KE3. The driver features a fiber-optic interface, a built-in DC/DC power supply and a selectable operating mode via a jumper. For drivers adapted to other types of high-power and high-voltage IGBT modules, refer to www.IGBT-Driver.com/go/plug-and-play Product Highlights Applications Plug-and-play solution Three/multi-level converters Protects the IGBT from short-circuit failure Two-level converters Active clamping of V at turn-off Medium-voltage converters ce di/dt feedback at turn-off Industrial drives Extremely reliable long service life Traction No electrolytic capacitors Railroad power supplies Gate current up to 36A Wind-power converters Electrical insulation 4000 V Radiology and laser technology AC Fiber-optic links Research Monitoring of supply voltage and fiber optics Almost all other conceivable Switching frequency DC to max. 6.5kHz applications Duty cycle 0... 100% Built-in DC/DC power supply Shortens application development time IGBT-Driver.com Page 1 1SD536F2 Data Sheet 1SD536F2-FZ2400R12KE3 Important Notes This data sheet contains only product-specific data. For a detailed description, must- read application notes and common data that apply to the whole series, please refer to the Description & Application Manual for 1SD536F2 SCALE High-Power IGBT Drivers. When applying SCALE plug-and-play drivers, please note that these drivers are specifically adapted to a particular type of IGBT module. Therefore, the type designation of SCALE plug-and-play drivers also includes the type designation of the corresponding IGBT module. These drivers are not valid for IGBT modules other than those specified. Incorrect use may result in failure. Mechanical and Electrical Interfaces Dimensions: 193 x 50mm. Mounting Principle: Direct screw mount on IGBT. Interface Remarks Part type Drive signal input (Standard) Fiber-optic receiver (Notes 16,18) HFBR-2522 Drive signal input (Opt. 01) Fiber-optic receiver (Notes 16,20) HFBR-2412T Status output (Standard) Fiber-optic transmitter (Notes 16,19) HFBR-1522 Status output (Opt. 01) Fiber-optic transmitter (Notes 16,21) HFBR-1412T Power supply connector On-board connector (Note 17) 77315-101-05 Power supply connector Designator Pin numbers Ground GND 1, 2, 4, 5 Supply voltage V 3 DC Absolute Maximum Ratings Parameter Remarks Min Max Units Supply voltage V VDC to GND (Note 1) 0 16 V DC Gate peak current I Note 8 -36 +36 A out Average supply current I Note 3 500 mA DC Output power DC/DC converter Notes 3,12 5 W Switching frequency Note 12 6.5 kHz Test voltage (50Hz/1min) Primary to output (Note 15) 4000 V AC(eff) DC-link voltage Note 5 800 V Operating temperature Note 12 -40 +85 C Storage temperature -40 +90 C Page 2 CT-Concept.com