2SP0320T2Cx-12 2SP0320T2Cx-12 Preliminary Data Sheet Compact, high-performance, plug-and-play dual-channel IGBT driver based on SCALE-2 technology for individual and parallel-connected modules in 2-level, 3-level and multilevel converter topologies Abstract The SCALE-2 plug-and-play driver 2SP0320T2Cx-12 is a compact dual-channel intelligent gate driver designed for 1200V IGBT modules from Danfoss, Fuji or Infineon. The driver features an electrical interface with a built-in DC/DC power supply. The turn-on and turn-off gate resistors of both channels are not assembled in order to provide maximum flexibility. They must be assembled by the user before start of operation. Please refer to the paragraph on Gate Resistor Assembly for the recommended gate resistors. For drivers adapted to other types of high-power and high-voltage IGBT modules, refer to www.IGBT-Driver.com/go/plug-and-play Features Applications Plug-and-play solution Wind-power converters Allows parallel connection of IGBT modules Industrial drives For 2-level, 3-level and multilevel topologies UPS Shortens application development time Power-factor correctors Extremely reliable long service life Traction Built-in DC/DC power supply Railroad power supplies 20-pin flat cable interface Welding Duty cycle 0... 100% SMPS Active clamping of V at turn-off Radiology and laser technology ce IGBT short-circuit protection Research Monitoring of supply voltage and many others Safe isolation to EN 50178 UL compliant Suitable for 1200V IGBT modules Gate resistors not assembled www.IGBT-Driver.com Page 1 2SP0320T2Cx-12 Preliminary Data Sheet Safety Notice The data contained in this data sheet is intended exclusively for technically trained staff. Handling all high- voltage equipment involves risk to life. Strict compliance with the respective safety regulations is mandatory Any handling of electronic devices is subject to the general specifications for protecting electrostatic-sensitive devices according to international standard IEC 60747-1, Chapter IX or European standard EN 100015 (i.e. the workplace, tools, etc. must comply with these standards). Otherwise, this product may be damaged. Important Product Documentation This data sheet contains only product-specific data. For a detailed description, must-read application notes and common data that apply to the whole series, please refer to Description & Application Manual for 2SP0320T SCALE-2 IGBT Drivers on www.IGBT-Driver.com/go/2SP0320. The gate resistors on this gate driver are not assembled in order to provide maximum flexibility. For the gate resistors required for specific IGBT modules, refer to the paragraph on Gate Resistor Assembly. Use of gate resistors other than those specified may result in failure. Mechanical Dimensions Dimensions: See the relevant Description and Application Manual Mounting principle: Connected to IGBT module with screws Absolute Maximum Ratings Parameter Remarks Min Max Unit Supply voltage V VDC to GND 0 16 V DC Supply voltage V VCC to GND (Note 1) 0 16 V CC Logic input and output voltages To GND -0.5 VCC+0.5 V SO current Fault condition, total current 20 mA x Gate peak current I Note 2 -20 +20 A out Average supply current I Note 16 600 mA DC Output power per gate Ambient temperature <70C (Note 3) 3 W Ambient temperature 85C (Note 3) 2 W Turn-on gate resistance Note 17 0.3 Turn-off gate resistance Note 17 1 Switching frequency F Note 23 n.d. kHz Test voltage (50Hz/1min.) Primary to secondary (Note 19) 3800 V AC(eff) Secondary to secondary (Note 19) 3800 V AC(eff) DC-link voltage Note 4 800 V dV/dt Rate of change of input to output voltage (Note 20) 50 kV/s Operating voltage Primary/secondary, secondary/secondary 1200 V peak www.IGBT-Driver.com Page 2