PEL00581 Pro Elec

Model No. PEL00581 NON MAINTAINED TWIN SPOTLIGHT WALL MOUNT LED EMERGENCY LIGHT 1Please read these instructions carefully before starting installation and retain for future reference. The centre page test record can be removed and kept with the building fire safety records. IMPORTANT SAFETY INFORMATION RISK OF ELECTRICAL SHOCK. ALWAYS ISOLATE THE POWER AT THE MAINS BEFORE INSTALLING OR MAINTAINING THIS EMERGENCY LIGHT. This product must be installed by a competent person in accordance with the Building Regulations and the current edition of the IET Wiring Regulations (BS7671). This product is suitable for mounting on normally flammable surfaces such as wood, plasterboard or masonry. Emergency light fittings should have their own separate mains circuit, protected with an appropriate MCB or fuse. They should not share their supply with other lighting or electrical equipment. The emergency light is suitable for connection to a 220-240V~ 50Hz. This emergency light is for indoor use only. This product will only illuminate in the event of a mains failure (non-maintained). Ensure that after installation the emergency light remains accessible for regular maintenance and testing. INSTALLATION NOTE: Before drilling any holes, check that there are no hidden obstructions behind the mounting surface such as pipes or cables. 1. Undo the four screws on the front of the main body and lift the panel off. 2. The position of the cable entry and fixing holes are marked on the case. Remove and open out as required. 3. Using the back of the product as a template, mark the position of the fixing holes on your mounting surface (see fig 1). 4. Drill the fixing holes and fit wall plugs as appropriate. 5. Secure the back of the product to the mounting surface using suitable fixings (not supplied). 6. Fit a cable gland (not supplied) into the cable entry hole. Apply silicone sealant to the fixings if moisture or weatherproofing is required. 7. Thread the supply cable through into the product and fit the cable retainer . 8. Make connection to the supply using the terminal block on the PCB. Ensure that the correct polarities are observed i.e.: Brown Live terminal L Blue Neutral terminal N 9. Write the current date on the battery pack. 10. Connect the battery pack terminal connector to the connector on the PCB. 11. Fit the front cover and restore the power supply. The green LED should light to show the battery is being charged. 12. Perform the electrical tests specified in the Wiring Regulations (BS7671). 2