PEL00589 Pro Elec

Model No. PEL00589 MAINTAINED LED SQUARE EMERGENCY CEILING LIGHT 1Please read these instructions carefully before starting installation and retain for future reference. The centre page test record can be removed and kept with the building fire safety records. IMPORTANT SAFETY INFORMATION RISK OF ELECTRICAL SHOCK. ALWAYS ISOLATE THE POWER AT THE MAINS BEFORE INSTALLING OR MAINTAINING THIS EMERGENCY LIGHT. This product must be installed by a competent person in accordance with the Building Regulations and the current edition of the IET Wiring Regulations (BS7671). This product is suitable for mounting on normally flammable surfaces such as wood, plasterboard or masonry. Emergency light fittings should have their own separate mains circuit, protected with an appropriate MCB or fuse. They should not share their supply with other lighting or electrical equipment. This product is suitable for connection to a 220-240V~ 50Hz, fixed wiring supply . This product must be earthed. For indoor use only. Ensure that after installation the equipment remains accessible for regular maintenance and testing. INSTALLATION NOTE: Before drilling any holes, check that there are no hidden obstructions behind the mounting surface such as pipes or cables. 1. Loosen the 4 screws on each side of the diffuser and remove it. 2. Remove the 2 screws holding the main assembly plate into the main casing and allow the plate to swing clear on its pivot. NOTE: the plate assembly can with care, be removed from its hinge in the casing, to aid initial installation of the product to the mounting surface. 3. Create a wiring access hole centrally in the base of the casing where marked. 4. Drill holes through the moulded mounting position indicators as required. 5. Using the casing of the product as a template, mark the position of the fixing holes on your mounting surface. 6. Drill the fixing holes and fit wall plugs as appropriate. 7. Feed the mains supply wiring through the central hole and secure the casing to the mounting surface using suitable fixings (not supplied). 8. Refit the plate assembly to its hinge (if previously removed) and make connection to the mains supply using the screw terminal block attached to the plate. Ensure that the correct polarities are observed i.e.: Brown Live terminal L Blue Neutral terminal N. Green/Yellow Earth terminal E Link wire L to SW can be removed to change between maintained and non- maintained. 9. Write the current date on the battery pack. 10. Connect the battery pack terminal connector to the in-line connector on the wiring to the emergency module. 2