50-14795 Pro Signal

Universal Replacement Television Stand Assembly / Use Manual This universal replacment televison base is intended use with televisions with 60 diagonal screen measurement or less, and weighing less than 60 pounds. Please note that televisons differ greatly in size and weight distribution, and no two installation circumstances are the same. It is the users responsibility to ensure suitability of this product for each individual situation. Please read this document completely prior to use. Model 50-14795 www.mcmelectronics.comIdentify and verify all of the included hardware When unpacking the hardware, note that the glass base (B4) and rear pedestal (B3) and all associated hardware are in the main outer box. Inside the sub box you will find the wall mount pieces (B1 x 2) and (B2). To begin, place the glass base (B4) on a flat surface with the shiny side facing upwards. Locate the following parts: Rear pedestal (B3) (2) support rods (A1) (2) plastic end caps (A10). Plastic end caps are intended to attach to both sides of the rear pedestal. Metal top plate (A11) (2) Cap nuts (A2) (2) Metal washers (A3) outside diameter 3/4 (2) Plastic washers (A4) outside diameter 3/4 Step One: Insert both rods (A1) into the appropriate threaded openings in the glass base. Using a pair of pliers, tighten the rods until they are just snug. Take one plastic end cap and place over the rod, so the opening for the pedestal is facing upward. The rounded edge of the end cap will also face upward.