RFFM4293 RFFM4293 3.0V to 5.0V, 2.4GHz to 2.5GHz 802.11b/g/n/ac WiFi Front End Module Package: Laminate, 16-pin, 3.0mm x 3.0mm x 1.05mm The RFFM4293 provides a complete integrated solution in a single front end module (FEM) for WiFi 802.11b/g/n/ac and Bluetooth systems. Features The ultra-small form factor and integrated matching greatly reduces the Integrated 2.4GHz to 2.5GHz number of external components and layout area in the customer b/g/n/ac Amplifier, LNA with bypass mode, SP3T Switch, and application. This simplifies the total front end solution by reducing the bill Power Detector Coupler of materials, system footprint, and manufacturability cost. The Single Supply Voltage 3.0V to 5.0V RFFM4293 integrates a 2.4GHz to 2.5GHz power amplifier (PA), low P = 19dBm, 3.3V 3% noise amplifier (LNA) with bypass mode, power detector coupler for OUT Dynamic EVM. improved accuracy, and some filtering for harmonic rejection. The P = 21dBm, 5.0V 3% OUT device is provided in a 3mm x 3mm x 1.05mm, 16-pin package. This Dynamic EVM module meets or exceeds the RF front end needs of IEEE Applications 802.11b/g/n/ac WiFi RF systems. IEEE802.11b/g/n/ac WiFi Applications VDD GND BT LNA EN 2.4GHz to 2.5GHz ISM Band 12 11 10 9 Solutions C BT 13 8 RX Portable Battery-Powered Equipment C RX 14 7 GND WiFi Access Points, Gateways, and Set Top Boxes GND 15 6 PA EN 5 TX ANT 16 1 2 3 4 PDET NC VCC VCC Functional Block Diagram Ordering Information RFFM4293SB Standard 5-piece bag RFFM4293SQ Standard 25-piece bag RFFM4293SR Standard 100-piece reel RFFM4293TR7 Standard 2500-piece reel RFFM4293PCK-410 Fully assembled evaluation board w/5-piece bag RF Micro Devices Inc. 7628 Thorndike Road, Greensboro, NC 27409-9421 DS140506 For sales or technical support, contact RFMD at +1.336.678.5570 or customerservice rfmd.com. RF MICRO DEVICES and RFMD are trademarks of RFMD, LLC. BLUETOOTH is a trademark owned by Bluetooth SIG, Inc., U.S.A. and licensed for use by RFMD. All other trade names, trademarks, and registered trademarks are the property of their respective owners. 2013, RF Micro Devices, Inc. 1 of 9 RFFM4293 Absolute Maximum Ratings Caution ESD sensitive device. Parameter Rating Unit DC Supply Voltage (Continuous with No Damage) 5.4 V DC Supply Current 500 mA RFMD Green: RoHS status based on EU Operating Case Temperature -20 to +85 C Directive 2011/65/EU (at time of this document revision), halogen free per IEC Extended Temperature Range (with Reduced Performance) -40 to -20 C 61249-2-21, < 1000ppm each of antimony Storage Temperature -40 to +150 C trioxide in polymeric materials and red phosphorus as a flame retardant, and Maximum Tx Input Power into 50 Load +12 dBm <2% antimony in solder. Maximum Rx Input Power (No Damage) +12 dBm Exceeding any one or a combination of the Absolute Maximum Rating conditions may cause permanent Moisture Sensitivity MSL3 damage to the device. Extended application of Absolute Maximum Rating conditions to the device may reduce device reliability. Specified typical performance or functional operation of the device under Absolute Maximum Rating conditions is not implied. Nominal Operating Parameters Specification Parameter Unit Condition Min Typ Max Temperature = -10C to +70C, V = 3.3V, CC Typical Conditions 3.3V PA EN = high, P = 19dBm using an IEEE802.11n MCS7 OUT waveform unless otherwise noted. Tx Performance - 11g/n/ac Compliance with standard 802.11g/n/ac Frequency 2412 2484 MHz 802.11n Output Power 18.5 19.0 dBm 802.11n HT20 and HT40 MCS7 at 25C 11n Dynamic EVM 2.5 3 % -32.0 -30.5 dB 802.11ac Output Power 16.5 17.0 dBm 802.11ac HT40 MCS9 at 25C 11ac Dynamic EVM 1.5 1.8 % -36.0 -35.0 dB Tx Performance - Spectral Mask 802.11n Output Power 21 dBm 802.11n HT20 and HT40 MCS7 at 25C 802.11b Output Power 24 dBm Meet 802.11b DSSS 1Mbps Spectral Mask General Tx Performance Second Harmonic -24 -20 dBm/MHz At P = 19dBm OUT Third Harmonic -50 -42 dBm/MHz Gain 25 27 29 dB Gain Variation Over Temp -2 +2 dB Power Detect Voltage 0.11 0.125 0.14 V RF = off 0.7 0.8 0.9 V At rated P OUT Power Detect Accuracy -2.0 +2.0 dB Into 3:1 VSWR load at 25C Input Return Loss - Tx in pin -13 -10 dB In specified frequency band Output Return Loss at ANT pin -15 -10 dB Operating Current 210 230 mA At rated P 19dBm OUT 195 215 mA At rated P 17dBm OUT Quiescent Current 170 mA Nominal conditions no RF applied Leakage Current 2 10 A V = 3.3V, PA EN = low, C RX = low, LNA EN = low CC Power Added Efficiency 10.5 % Nominal conditions Power Supply - V 3.0 3.3 3.6 V CC RF Micro Devices Inc. 7628 Thorndike Road, Greensboro, NC 27409-9421 DS140506 For sales or technical support, contact RFMD at +1.336.678.5570 or customerservice rfmd.com. The information in this publication is believed to be accurate. However, no responsibility is assumed by RF Micro Devices, Inc. RFM) for its use, nor for any infringement of patents or other rights of third parties resulting from its use. No license is granted by implication or otherwise under any patent or patent rights of RFMD. RFMD reserves the right to change component circuitry, recommended application circuitry and specifications at any time without prior notice. 2 of 9