35W Class II AC-DC LED Power Supply Features LIGHTLINE 500, 700, 1000, 1400mA or 2500mA Output AC/DC-Converter Active Power Factor Correction >0.90 LED DRIVER Efficiency up to 83% with 5 year Warranty IP67 Certified 3 in 1 Dimming Description The 35W LED drivers of the RACD35-A series come with a 3-in-1 dimming function so that the LED load can be dimmed with analog (1-10V), PWM, or resistor inputs. Due to wide input voltage range of 90 - 305VAC these LED drivers are suitable for worldwide use. They operate with efficiencies of up to 83%, feature active PFC, and are fully protected against short circuit, overvoltage, and over-temperature conditions. They are sealed against damp and wet conditions, and the warranty is 5 years. 35 Watt PFC Selection Guide Single Part Rated Output Output Efficiency Number Power Current Voltage (typ.) Output (W) (mA) (VDC) (%) RACD35-500A 28.5 500 48 - 57 82 230 500 21-39 Triac 82 RACD35-700A 33,6 700 33 - 48 79 RACD35-1000A 36 1000 24 - 36 82 12-18 RACD35-1400A 33.6 1400 12 - 24 81 RACD35-2500A 30 2500 9 - 12 80 Specifications (measured at 240VAC and 25C ambient temperature) RoHS 2011/65/EU Input Voltage Range 90-305 VAC 6/6 E340696 Input Frequency Range 47-63Hz Power Factor Full Load, 277VAC >0.90 UL8750 Certified EN61347 Certified Full Load, 230VAC >0.95 EN55015 Certified Full Load, 110VAC >0.98 EN61547 Certified AC Input Current 110VAC 0.5A 230VAC 0.3A Inrush Current (Max.) 264VAC Cold Start 60A RACD35-A Leakage Current 230VAC <0.25mA Output Current Accuracy (includes Line Regulation, Load Regulation and set-up tolerance) 5% Isolation Voltage 3.75kVAC / 1minute Short Circuit Protection Hiccup mode & recovers after fault condition removed Over Voltage Protection 115% - 135% Output Voltage Latch Mode Over Temperature Protection Thermistor 105C 10C Derating-Graph Type Latch Mode Dimming Control: PWM 1<Adj<10V(500Hz - 3kHz) (Ambient Temperature) Analogue control by external voltage 1-10VDC Resistance 10K - 100K A Set Up Time Full Load, 230VAC 2 sec Storage Humidity 10% - 95% RH . A Operating Humidity 20% - 95% RH Non-Condensing - A Weight 384g ) 2 0 3+2 , A Dimension (LxBxH) 110 x 73.5 x 33mm Operating Temperature Range Full load -20C to +50C A (free air convection - 10LFM) Case Temperature 85C 10C 0 + Storage Temperature -40C to +80C ) IP Rating IP67 Isolation Resistance 500VDC 100M Note: All LED Drivers may not be used without a MTBF (+25C) using MIL-HDBK 217F 200 x 10 hours load. They must be switched on the primary Certifications: side only. Noncompliance may damage the LED or reduce its lifetime. UL Standards Report: E340696 UL8750, (based on) UL1310 Safety Standards Report: P201403013 EN61347-1 EN61347-2-13 Refer to Application Notes continued on next page L-46 REV: 0/2015 www.recom-power.com NOT RECOMMENDED FOR NEW DESIGNSRACD35-A RACD35-A LIGHTLINE AC/DC-Converter Series Specifications (measured at 240VAC and 25C ambient temperature) Emission Report: HA130831-SACE EN55015, Class B IEC61000-3-2 IEC61000-3-3 FCC Report: HA130831-SAFD Part 15, Class B EMC Report: HA130831-SACE IEC61000-4-2, 3, 4, 5, 6, 8, 11 Immunity EN61547 IP67 Report: 14022002 IEC/EN 60598-1 IEC/EN 60529 Technical Characteristics Load vs. Input Voltage Dimming Curve B + A . A - A , A A ) 2 2 E E 7 3 + * . , 3+ A A 8 2 2) - - Maximum Number of LED drivers per circuit breakers Condition Circuit Breaker Circuit Breaker Current Typ 10A 16A 20A 25A 115VAC, 1Ohm C 22 35 39 55 90 phase angle B 18 30 35 43 230VAC, 1Ohm 90 phase angle C 29 46 55 69 B 21 34 41 50 277VAC, 1Ohm 90 phase angle C 33 52 63 79 Package Style & Pinning F .) ) 9 4 ) 4 5 ,-, .) , 21 7 20 4 (> 1 4 0 The product information and specifications are subject to change without prior notice. RECOM products are not authorized for use in safety-critical applications (such as life support) without RECOMs explicit written consent. A safety-critical application is defined as an application where a failure of a RECOM product may reasonably be expected to endanger or cause loss of life, inflict bodily harm or damage property. The buyer shall indemnify and hold harmless RECOM, its affiliated companies and its representatives against any damage claims in connection with the unauthorized use of RECOM products in such safety-critical applications. www.recom-power.com REV: 0/2015 L-47 (