R w a A r E r Low Cost 230VAC LED Power Supply Features 350mA to 1050mA Output, 25-44VDC Active Power Factor Correction >0.95 AC/DC Converter Designed to drive 15W-46W COB LEDs LED Terminal Block Input/Output with Cable Clamps Fully Protected (OLP, SCP, OCP, OTP) Driver RCOB Suitable for Class I and Class II Luminaires Description Constant These COB LED drivers are available with eleven preset output currents between 350mA and 1050mA. 3 They are designed to drive COB (Chip On Board) high power LEDs with a forward voltage between Current 25V and 44VDC from a 230VAC supply (198-264VAC). They operate with efficiencies of up to 90%, feature active PFC and are fully protected against short circuit, output overvoltage, open-circuit and Active PFC over-temperature conditions. The LED drivers are suitable for both independent and built-in installations and for installations inside furniture. Single Output Selection Guide Part Input Output Output Efficiency Rated Number Voltage Range Voltage Range Current typ. Power VAC VDC mA % W RCOB-350 198-264 25-44 350 87 15 RCOB-400 198-264 25-44 400 87 17 RCOB-450 198-264 25-44 450 88 20 NOT RECOMMENDED RCOB-500 198-264 25-44 500 88 22 RCOB-550 198-264 25-44 550 88 24 RCOB-600 198-264 25-44 600 89 26 FOR RCOB-650 198-264 25-44 650 89 28 RCOB-700 198-264 25-44 700 89 31 EN-61347-1 Compliant EN-61347-2-13 Compliant RCOB-800 198-264 25-44 800 90 35 EN-55015 Compliant NEW DESIGNS RCOB-900 198-264 25-44 900 90 40 EN-61547 Compliant RCOB-1050 198-264 25-44 1050 90 46 EN-61000-3-2 Compliant EN-61000-3-3 Compliant All LED Drivers may not be used without a load. They must be switched on the primary side only. Noncompliance may damage the LED or reduce its lifetime. Specifications (measured ta= 25C, 230VAC and rated load) BASIC CHARACTERISTICS Parameter Condition Min. Typ. Max. Input Voltage Range 198VAC 230VAC 264VAC Inrush Current 10s 8A Start-up Time 1s Input Frequency Range 47Hz 63Hz Power Factor full load 0.95 continued on next page www.recom-power.com REV.: 3/2016 L-1 a Y n t 3 yRCOB AC/DC Converter Series Specifications (measured ta= 25C, 230VAC and rated load) Efficiency vs. Output Voltage RCOB-500 95 90 85 80 75 70 60 50 70 80 90 100 Output Voltage % REGULATIONS Parameter C ondition Value Output Current Accuracy includes: line, load and tolerance 8% typ. PROTECTION Parameter Condition Value Input Fuse T1A, slow blow Short Circuit Protection (SCP) constant current limit at I and recovers after fault condition is removed nominal Over Load Protection (OLP) power limiting if forward voltage of LEDs is higher than 44VDC Output Over Voltage Protection (OVP) Zener clamp 56VDC max. Output Over Current Protection (OCP) constant current source Over Temperature Protection (OTP) automatic recovery after cool down Isolation Voltage 3kVAC / 1 minute L-N 2kV Surge Capacity L,N-FG 4kV Maximum loading of automatic circuit breakers* * 230VAC, 1Ohm, 90 phase angle and max. load Circuit Breaker Circuit Breaker Current Power Typ 10A 16A 20A 25A B 61 100 121 150 7W C 121 164 221 291 B 35 57 69 85 15W C 57 87 109 134 B 24 38 46 58 25W C 38 62 74 92 B 18 30 35 43 35W C 29 46 55 69 B 17 28 33 41 45W C 24 39 47 57 L-2 REV.: 3/2016 www.recom-power.com Efficiency %