74CBTLV3861QG Renesas

74CBTLV3861 LOW-VOLTAGE 10-BIT BUS SWITCH INDUSTRIAL TEMPERATURE RANGE LOW-VOLTAGE 10-BIT 74CBTLV3861 BUS SWITCH FEATURES: DESCRIPTION: 5 A/B bi-directional switch The CBTLV3861 provides ten bits of high-speed bus switching with low Isolation under power-off conditions on-state resistance of the switch allowing connections to be made with Over-voltage tolerant minimal propagation delay. Latch-up performance exceeds 100mA The device is organized as one 10-bit bus switch. When output enable VCC = 2.3V - 3.6V, Normal Range (OE) is low, the 10-bit bus switch is on and port A is connected to port B. ESD > 2000V per MIL-STD-883, Method 3015 When OE is high, the switch is open and a high-impedance state exists > 200V using machine model (C = 200pF, R = 0) between the two ports. Available in QSOP and TSSOP packages To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor the minimum value of the resistor is determined by the current-sinking capability of the driver. APPLICATIONS: 3.3V High Speed Bus Switching and Bus Isolation FUNCTIONAL BLOCK DIAGRAM SIMPLIFIED SCHEMATIC, EACH SWITCH 2 22 A1 SW B1 A B 11 13 A10 SW B10 23 OE OE INDUSTRIAL TEMPERATURE RANGE MAY 2019 1 2019 Integrated Device Technology, Inc. DSC-5741/774CBTLV3861 LOW-VOLTAGE 10-BIT BUS SWITCH INDUSTRIAL TEMPERATURE RANGE (1) PIN CONFIGURATION ABSOLUTE MAXIMUM RATINGS Symbol Description Max Unit VCC SupplyVoltage Range 0.5 to +4.6 V VI Input Voltage Range 0.5 to +4.6 V NC 1 24 VCC Continuous Channel Current 128 mA A1 223 OE IIK Input Clamp Current, VI/O < 0 50 mA TSTG Storage Temperature 65 to +150 C A2 3 22 B1 NOTE: A3 B2 1. Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS may cause 4 21 permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational A4 5 20 B3 sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. A5 6 19 B4 A6 7 18 B5 A7 8 17 B6 A8 9 16 B7 A9 10 15 B8 A10 11 14 B9 (1) FUNCTION TABLE GND 12 13 B10 Input OE Operation L A Port = B Port TOP VIEW H Disconnect NOTE: Package Type Package Code Order Code 1. H = HIGH Voltage Level L = LOW Voltage Level TSSOP PGG24 PGG QSOP PCG24 QG (1) OPERATING CHARACTERISTICS, TA = 25C Symbol Parameter Test Conditions Min. Max. Unit VCC Supply Voltage 2.3 3.6 V VIH High-Level Control Input Voltage VCC = 2.3V to 2.7V 1.7 V VCC = 2.7V to 3.6V 2 VIL Low-Level Control Input Voltage VCC = 2.3V to 2.7V 0.7 V VCC = 2.7V to 3.6V 0.8 TA Operating Free-Air Temperature 40 85 C NOTE: 1. All unused control inputs of the device must be held at VCC or GND to ensure proper device operation. 2