Preliminary Datasheet Specifications in this document are tentative and subject to change. RL78/L13 R01DS0168EJ0002 Rev.0.02 RENESAS MCU 2012.10.31 Integrated LCD controller/driver, True Low Power Platform (as low as 112.5 A/MHz, and 0.61 A for RTC + LVD), 1.6 V to 5.5 V operation, 16 to 128 Kbyte Flash, 31 DMIPS at 24 MHz, for All LCD Based Applications 1. OUTLINE 1.1 Features Supports capacitor split method, internal voltage Ultra-Low Power Technology boost method and resistance division method 1.6 V to 5.5 V operation from a single supply Supports waveform types A and B Stop (RAM retained): 0.25 A, (LVD enabled): 0.33 A Supports LCD contrast adjustment (18 steps) Halt (RTC + LVD): 0.61 A Supports LCD blinking Supports snooze Data Memory Access (DMA) Controller Operating: 112.5 A/MHz Up to 4 fully programmable channels LCD operating current (Capacitor split method): 0.29 A Transfer unit: 8- or 16-bit LCD operating current (Internal voltage boost Multiple Communication Interfaces method): 0.68 A 2 Up to 2 x I C master 2 C multi-master 16-bit RL78 CPU Core Up to 1 x I Up to 2 x CSI (7-, 8-bit) Delivers 31 DMIPS at maximum operating frequency of 24 MHz Up to 4 x UART (7-, 8-, 9-bit) Up to 1 x LIN Instruction Execution: 86% of instructions can be executed in 1 to 2 clock cycles Extended-Function Timers CISC Architecture (Harvard) with 3-stage pipeline Multi-function 16-bit timer TAU: Up to 8 channels Multiply Signed & Unsigned: 16 x 16 to 32-bit result in (remote control output available) 1 clock cycle Multi-function 16-bit timer KB20: 1 channel MAC: 16 x 16 to 32-bit result in 2 clock cycles High accuracy real-time clock (RTC005): 1 channel 16-bit barrel shifter for shift & rotate in 1 clock cycle (full calendar and alarm function with watch 1-wire on-chip debug function correction function) 12-bit interval timer: 1 channel Code Flash Memory 15 kHz watchdog timer: 1 channel (window function) Density: 16 KB to 128 KB Block size: 1 KB Rich Analog On-chip single voltage flash memory with protection ADC: Up to 12 channels, 8/10-bit resolution, 2.1 s from block erase/writing minimum conversion time Self-programming with secure boot swap function Supports 1.6 V and flash shield window function Internal voltage reference (1.45 V) On-chip temperature sensor Data Flash Memory Data Flash with background operation Safety Features (IEC or UL 60730 compliance) Data flash size: 4 KB Flash memory CRC calculation Erase Cycles: 1 Million (typ.) RAM parity error check Erase/programming voltage: 1.8 V to 5.5 V RAM write protection SFR write protection RAM Illegal memory access detection 1 KB to 8 KB size options Clock stop/ frequency detection Supports operands or instructions ADC self-test Back-up retention in all modes I/O port read back function (echo) High-speed On-chip Oscillator General Purpose I/O 24 MHz with +/ 1% accuracy over voltage (1.8 V to 5 V tolerant, high-current (up to 20 mA per pin) 5.5 V) and temperature ( 20 C to +85 C) Open-Drain, Internal Pull-up support Pre-configured settings: 48 MHz, 24 MHz, 16 MHz, 12 MHz, 8 MHz, 4 MHz & 1 MHz (TYP.) Operating Ambient Temperature <R> Consumer application: 40C to + 85C Reset and Supply Management Industrial application: 40C to + 105C Power-on reset (POR) monitor/generator Low voltage detection (LVD) with 14 setting options Package Type and Pin Count (Interrupt and/or reset function) 64-pin plastic LQFP (fine pitch) (10 x 10) 64-pin plastic LQFP (12 x 12) LCD Controller/Driver 80-pin plastic LQFP (fine pitch) (12 x 12) <R> Up to 51 seg x 4 com or 48 seg x 8 com 80-pin plastic LQFP (14 x 14) R01DS0168EJ0002 Rev.0.02 Page 1 of 11 2012.10.31 Preliminary document Under development Specifications in this document are tentative and subject to change. RL78/L13 1. OUTLINE ROM, RAM capacities Flash ROM Data flash RAM RL78/L13 64 pins 80 pins Note 8 KB 128 KB 4 KB R5F10WLG R5F10WMG 96 KB 4 KB 6 KB R5F10WLF R5F10WMF 64 KB 4 KB 4 KB R5F10WLE R5F10WME 48 KB 4 KB 2 KB R5F10WLD R5F10WMD 32 KB 4 KB 1.5 KB R5F10WLC R5F10WMC 16 KB 4 KB 1 KB R5F10WLA R5F10WMA Note This is about 7 KB when the self-programming function and data flash function are used. R01DS0168EJ0002 Rev.0.02 Page 2 of 11 2012.10.31