RTK7921053S00000BE Renesas

Renesas Evaluation Board Kit Quick Start for RZ/A2M MIPI Camera Header CPU Board Reset Switch User LED MIPI 8MP Power LED Power Switch Camera Board Debugger Header User Switches CPU Board Socket Display Output Board Sub Board J-Link Lite Debugger USB Power USB Serial (Mini USB) (Micro USB) 2 NOTE: This Quick Start Guide covers installation of the e studio IDE (available from 2. Preparing the Evaluation Board Kit 3. Connect the CPU board to the sub board using the 204-pin connector (note the key slot is to the left of centre). Orientate at approximately 45 from horizontal, inserting the edge connector fully into the socket before gently rotating the CPU board down flat until the clamps lock the board in place. Actions for inserting CPU 1 Board in Sub Board CN1 2 CN1 Sub Board 4. Connect the Display Output Board to the display connector (CN15 LCD) on the sub board. The central key ensures correct orientation by aligning it with the slot in the socket. 5. Connect the Display Output Board to an external monitor capable of 800x600 resolution using a monitor cable (not supplied). 6. Connect the camera module to the camera connector (CN2 MIPI) on the CPU board. Open the connector by pulling up on the tags at either side, then insert the cameras ribbon cable. The correct orientation is with the contacts on the ribbon cable facing the CPU, and the blue insulated rectangle to the outside. To hold the cable firmly, push down on the top of the connector until it clips in place. Pull tags to open Push centre to close 7. Connect the J-Link LITE Segger debugger module to the debugger connector (CN5 Coresight 20) on the CPU board using the ribbon cable. Ensure that pin 1 (red strand) mates with the triangle mark on the PCB silk screen. 8. Connect the debugger module to a USB port on the host PC. The green LED on the debugger will illuminate. 9. The debugger drivers will now be installed. Note that, this may take up to a minute and administrator privileges will be required. Windows 7 Windows 8.1 / 8 Windows 10 Device driver software installed An icon will appear in the Windows A Windows taskbar buttons of successfully pop-up will appear in Taskbar and installation will Device Setup will appear in the the Windows Taskbar and complete. Windows Taskbar and installation installation will complete. will complete. The Segger s J-Link LITE included in the evaluation kit is dedicated for the attached evaluation board. This J-Link LITE cannot be used for any other boards and products.