Datasheet PC259, 4560 R03DS0146EJ0100 High Performance, Low Noise Rev.1.00 2019.06.13 Dual Operational Amplifier DESCRIPTION The PC259 and 4560 are dual operational amplifier with a built-in phase compensation circuit. The electrical characteristics are equivalent to the PC258 and 4558, and can flow a large amount of output current. In addition, the slew rate is about 2.8 times of the PC258, 4558. Therefore, applications such as active filters, audio amplifiers and VCOs can be realized with a simple circuit configuration. Depending on the operating ambient temperature, PC259 is suitable for communication application while PC4560 is suitable for general-purpose usage. FEATURES Input Offset Voltage 0.5 mV (TYP.) Input Offset Current 5 nA (TYP.) Input Bias Current 60 nA (TYP.) Slew Rate 2.8 V/s (TYP.) Output Current over 25 mA Built-In Phase Compensation Circuit Standard Dual Op-Amp terminal connection (pin compatible) ORDERING INFORMATION Ordering Name Package PC259G2-A 8-pin plastic SOP ( 5.72 mm ( 225 mil)) PC4560G2-A 8-pin plastic SOP ( 5.72 mm ( 225 mil)) EQUIVALENT CIRCUIT (1/2 Circuit) PIN CONFIGURATION (Top View) + V R 1 PC259G2, PC4560G2 Q 7 Q Q 5 13 + Q OUT1 1 8 V 11 Q 15 Q 1 8 R 6 -+ I Q Q I 1 2 I 2 7 OUT2 I1 Q 9 R 7 R I 5 2 N C 2 + - Q Q 14 12 I3I6 N1 I2 Q 6 OUT Q Q Q 3 4 10 - V 4 5 I N2 D R R R R 2 C 3 4 8 1 - V R03DS0146EJ0100 Rev.1.00 Page 1 of 8 2019.06.13 PC259, 4560 ABSOLUTE MAXIMUM RATINGS (T = 25 C) A PARAMETER SYMBOL PC259G2 PC4560G2 UNIT Note1 + - Supply Voltage V - V -0.3 ~ +36 V Differential Input Voltage VID 30 V Note2 - + Input Voltage V V -0.3 ~ V +0.3 V I Note3 - + Output Applied Voltage VO V -0.3 ~ V +0.3 V Note4 Total Power Dissipation P 440 mW T Note5 Output Short Circuit Duration 0 s Operating Ambient Temperature T -40 ~ +85 -20 ~ +80 C A Storage Temperature Tstg -55 ~ +125 C Note 1. Note that reverse connections of the power supply may damage the ICs. 2. The input terminal must be apply within the input voltage range to avoid deteriorating or damaging the device characteristic. Do not exceed the ratings including during transition state such as ON/OFF, etc. The Op-Amp input voltage must operates within the electrical characteristics range of input common-mode voltage. 3. The output terminal must be apply within the output voltage range to avoid deteriorating or damaging the device characteristic. Do not exceed the ratings including during transition state such as ON/OFF, etc. The Op- Amp output voltage must operates within the electrical characteristics range of maximum output voltage. 4. This is the value at TA +25 C. De-rate value at -4.4 mW/ C when TA 25 C. 5. Protection against load shorts is required. Please use the total loss and the de-rating value from Note 4. RECOMMENDED OPERATING CONDITIONS PARAMETER SYMBOL MIN. TYP. MAX. UNIT Power Supply Voltage V 4 16 V R03DS0146EJ0100 Rev.1.00 Page 2 of 8 2019.06.13