Datasheet PC824, 4074 R03DS0152EJ0100 Rev.1.00 2019.11.12 Low Noise J-FET Input Quad Operational Amplifier DESCRIPTION The PC824 and 4074 are low noise versions operational amplifier of PC804 and 4084 series with the general-purpose J-FET input. Compared with the PC804 and 4084 series, various characteristics such as input referred noise, input offset voltage and input bias current have been improved. It is therefore ideal for application circuits such as preamplifiers and active filters for measurement, audio and measurement where low noise, high input impedance and high-speed characteristics are important. Depending on the operating ambient temperature, PC824 is suitable for communication application while PC4074 is suitable for general-purpose usage. Along with this series of lineup, the dual type op-amp PC822 and 4072 with same circuit configuration are also available. FEATURES Input Offset Voltage 2 mV (TYP.) Input Bias Current 30 pA (TYP.) Slew Rate 13 V/ s (TYP.) Unity Gain Frequency 3 MHz (TYP.) Input Referred Noise Voltage Density 17 nV/ Hz (TYP.) (f = 1 kHz) Built-In Phase Compensation Circuit Built-In Output Short Circuit Protection Standard Quad Op-Amp terminal connection (pin compatible) ORDERING INFORMATION Ordering Name Package PC824G2-A 14-pin plastic SOP ( 5.72 mm ( 225 mil )) PC4074G2-A 14-pin plastic SOP ( 5.72 mm ( 225 mil)) EQUIVALENT CIRCUIT (1/4 Circuit) PIN CONFIGURATION (Top View) R03DS0152EJ0100 Rev.1.00 Page 1 of 7 2019.11.12 UPC824, 4074 ABSOLUTE MAXIMUM RATINGS (T = 25 C) A PARAMETER SYMBOL PC824G2 PC4074G2 UNIT Note1 + - Supply Voltage V to V -0.3 to +36 V Differential Input Voltage VID 30 V Note2 - + Input Voltage V V -0.3 to V +0.3 V I Note3 - + Output Applied Voltage VO V -0.3 to V +0.3 V Note4 Total Power Dissipation P 550 mW T Note5 Output Short Circuit Duration indefinite s Operating Ambient Temperature T -40 to +85 -20 to +80 C A Storage Temperature Tstg -55 to +125 C Note 1. Note that reverse connections of the power supply may damage the ICs. 2. The input terminal must be applied within the input voltage range to avoid deteriorating or damaging the device characteristic. Do not exceed the ratings including during transition state such as ON/OFF, etc. The Op- Amp input voltage must operate within the electrical characteristics range of input common-mode voltage. 3. The output terminal must be applied within the output voltage range to avoid deteriorating or damaging the device characteristic. Do not exceed the ratings including during transition state such as ON/OFF, etc. The Op- Amp output voltage must operate within the electrical characteristics range of maximum output voltage. 4. This is the value at T +25 C. De-rate value at -5.5 mW/C when T > 25 C. A A 5. Please use below the total power dissipation and the de-rating value from Note 4. RECOMMENDED OPERATING CONDITIONS PARAMETER SYMBOL MIN. TYP. MAX. UNIT Power Supply Voltage V 5 16 V Load Current I 10 mA O Load Capacitance (When AV = +1) CL 100 pF R03DS0152EJ0100 Rev.1.00 Page 2 of 7 2019.11.12