AEC-Q200 RoHS Compliance This component is compliant with RoHS directive. This component was always RoHS compliant from the first date of manufacture. SF2275E-1 1542.5 MHz Low-loss SAW Filter Surface Mount 3.0 x 3.0 mm Package 1542 MHz Absolute Maximum Ratings Rating Value Units SAW Filter Input Power Level 15 dBm DC Voltage on any Non-ground Terminal 5 V Specification Temperature Range -40 to +105 C Storage Temperature Range in Tape and Reel -40 to +85 C Operable Temperature Range -40 to +125 C C Solder Reflow Temperature, 10 seconds, 5 cycles maximum 260 SM3030-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units f Center Frequency 1542 C MHz 3 dB Bandwidth 50 Insertion Loss, 1525 to 1559 MHz IL 2.8 3.0 dB Return Loss 10 dB dB Amplitude Ripple, 1525 to 1559 MHz 1.6 2.0 P-P Group Delay Ripple 1525 to 1559 MHz (2 MHZ sliding window) 8 10.0 ns 1525 to 1559 MHz (total pass band) 21 25.0 Attenuation, Referenced to 0 dB 0.3 to 1300 MHz 30 37 1300 to 1480 MHz 25 39 dB 1630 to 3500 MHz 30 32 3500 to 5000 MHz 28 5000 to 6000 MHz 16 Source Impedance Z 50 S Load Impedance Z 50 L Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 8U, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel Measurement Circuit Electrical Connections Network Analyzer Connection Terminals SF2275E-1 Input 2 Output 5 Ground All Others CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance matching to 50 and measured with 50 network analyzer. 2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4.LRI or after the part number indicateslow rate initial productio andEN or indicatesengineering prototypes 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All Rights Reserved January 2017 SF2275E-1 (Rev B) 10/18/18 Page 1 of 6 www.murata.comFrequency Characteristics Wideband Response: (0.3 to 3500 MHz) Narrowband Response: (span 200 MHz) Copyright Murata Manufacturing Co., Ltd. All Rights Reserved January 2017 SF2275E-1 (Rev B) 10/18/18 Page 2 of 6 www.murata.com