PSD2410 Sensata

PS24 Series Peak-fire SSR for high inductance applications Ratings from 10A to 90A 90- 280 VAC SCR output for heavy industrial loads DC control PRODUCT SELECTION Control Voltage 10A 25A 50A 90A 3-32 VDC PSD2410 PSD2425 PSD2450 PSD2490 AVAILABLE OPTIONS OUTPUT SPECIFICATIONS (1) Description 10A 25A 50A 90A Operating Voltage (47-63Hz) Vrms 90-280 90-280 90-280 90-280 Transient Overvoltage Vpk 600 600 600 600 Maximum Off-State Leakage Current Rated Voltage mArms 10 10 10 10 Minimum Off-State dv/dt Maximum Rated Voltage V/sec (2) 500 500 500 500 Maximum Load Current (3) Arms 10 25 50 90 Minimum Load Current mArms 40m 40 40 40 Maximum 1 Cycle Surge Current (50/60Hz) Apk 115/120 239/250 597/625 1145/1200 Maximum On-State Voltage Drop Rated Current Vpk 1.6 1.6 1.6 1.6 Thermal Resistance Junction to Case (Rjc) C/W 1.48 1.02 0.63 0.28 Maximum 1/2 Cycle I t for Fusing (50/60Hz) A2 sec 66/60 285/259 1779/1621 6560/5976 Minimum Power Factor (with Maximum Load) 0.5 0.5 0.5 0.5INPUT SPECIFICATIONS (1) Description DC Control Control Voltage Range 3-32 VDC Maximum Turn-On Voltage 3.0 VDC Minimum Turn-Off Voltage 1.0 VDC Maximum Reverse Voltage -32 Typical Input Current 2 mA(4) Nominal Input Impedance See Note 4 Maximum Turn-On Time msec 1/2 Cycle Maximum Turn-Off Time msec 1/2 Cycle GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz) 4000 Vrms 9 Minimum Insulation Resistance ( 500 V DC) 10 Ohm Maximum Capacitance, Input/Output 8 pF Ambient Operating Temperature Range -40 to 80 C Ambient Storage Temperature Range -40 to 125 C Weight (typical) 3.0 oz (86.5g) Encapsulation Thermally conductive Epoxy Terminals Screw and saddle Clamps Furnished, Unmounted Recommended Terminal Screw Torque Range: 6-32 Screws - 10 in/lbs. 8-32 & 10-32 Screws - 20 in. lbs. Fastons: Single pair (up to 25A) Double pair* (50A model only) *Caution: User must connect to both pairs GENERAL NOTES 1) All parameters at 25C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 3) Heat sinking required, for derating curves see page 3. 4) Input circuit incorporates active current limiter