GP1UX31QS Sharp

GP1UX31QS Series Holder-less Type IR Detecting Unit GP1UX31QS Series for Remote Control Features Outline Dimens ions (Unit : mm) 1. Holder-less shield case type. 2. Compact type. Conductive resin(GND) Strengthened resistance to electromagnetic 3. 2.1 3.2 induction noise by double mold method. 5.5 Operarting voltage 3V type. 4.  Applications  1. AV equipments 1.6 2. Home appliances 3. Toys using IR sensor 1.2 0.4 Absolute Maximum Ratings V cc 0.5  (Ta=25  *1 G ND 2.54 Parameter Symbol Rating Unit V out *1 2.54 Supply voltage V V 0 to +6.0 CC *1 Operating temperature T -10 to +70 opr Storage temperature T -20 to +70 Example of mounting drawing stg from solder side (Reference) *2 Soldering temperature T 265 sol *1 No dew condensation is allowed Top of lenz *2 For 6s (At mounting on PCB with thickness of 1.6mm) 1. *1 : Indicates root dimensions of connector. 2. Unspecified tolerance:0 .3 Recommended Operating Conditions  Parameter Symbol Operating conditions Unit Supply voltage V 2.7 to 5.5 V CC Notice The content of data sheet is subject to change without prior notice. In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device. Sheet No.: OP06013 1 28 7.5 6.9 6.0 8.8 4.1 2.8GP1UX31QS Series Model Line-up  Diversified models with a different B.P.F. frequency are also available. Model No. B.P.F. center frequency Unit 40 GP1UX31QS 36 GP1UX310QS kHz 38 GP1UX311QS 36.7 GP1UX312QS Internal Block Diagram R L V OUT Limiter B.P.F. Demodulator Integrator Comparator V CC GND Electro-optical Characteristics  (Ta=25, V CC=3V) Parameter Symbol Conditions MIN. TYP. MAX. Unit Dissipation current I No input light  0.27 0.4 mA CC *3 High level output voltage V VCC -0.5   V OH *3 Low level output voltage V IOL=1.6mA   V OL 0.45 *3 s High level pulse width T 600  1200 1 *3 Low level pulse width T 400  1000 s  2 *4 B.P.F. center frequency f    kHz 0 RL Output pull-up resistance  70 100 130 k *3 The burst wave as shown in the following figure shall be transmitted by the transmitter shown in Fig. 1 The carrier frequency of the transmitter, however, shall be same as *4, and measurement shall be from just after starting the transmission until 50 pulse The B.P.F. center frequency f0 varies with model, as shown in Model Line-up *4 
B urst wave s 1000s f =(*4) 0 Duty 50% Output signal Sheet No.: OP06013 2